Black & Decker HP146F4L manual Features, Assembly, Labels on tool

Read the instruction manual before use. Battery too hot

Charging process completed (continuous green light)

The charger is intended for indoor use only.

Warning! To reduce the risk of injury, the user must read the instruction manual.

uImpairment of hearing.

uHealth hazards caused by breathing dust developed when using your tool (example:- working with wood, especially oak, beech and MDF.)

Labels on tool

:The following pictograms are shown on the tool:

Additional safety instructions for batteries and chargers

Batteries

uNever attempt to open for any reason.

uDo not expose the battery to water.

uDo not store in locations where the temperature may exceed 40 °C.

uCharge only at ambient temperatures between 10 °C and 40 °C.

uCharge only using the charger provided with the tool.

uWhen disposing of batteries, follow the instructions given in the section "Protecting the environment".

7	Do not attempt to charge damaged batteries.
	Do not incinerate the battery.

Chargers

uUse your Black & Decker charger only to charge the battery in the tool with which it was supplied. Other batteries could burst, causing personal injury and damage.

uNever attempt to charge non-rechargeable batteries.

uHave defective cords replaced immediately.

uDo not expose the charger to water.

uDo not open the charger.

$u Do not probe the charger.

4

1

2

3 Charging (green flashing light)

5 Defective battery Low mains supply

#Your charger is double insulated; therefore no earth wire is required. Always check that the mains voltage corresponds to the voltage on the rating plate. Never attempt to replace the charger unit with a regular mains plug.Electrical safety

uIf the supply cord is damaged, it must be replaced by the manufacturer or an authorised Black & Decker Service Centre in order to avoid a hazard.

Features

This tool includes some or all of the following features.

1.Variable speed switch

2.Forward/reverse slider

3.Chuck

4.Mode selector / torque adjustment collar

5.Two-gear selector

6.Bit holder

7.Battery

Fig. A

8.Charger

9.Charger receptacle

10.Charging indicator

Assembly

Warning! Before assembly, remove the battery from the tool.

Fitting and removing the battery (fig. B)

uTo fit the battery (7), line it up with the receptacle on the tool. Slide the battery into the receptacle and push until the battery snaps into place.

uTo remove the battery, push the release button (11) while at the same time pulling the battery out of the receptacle.

Fitting the battery cap (fig. C)

Warning! Fit the cap (12) to the battery (7) for transportation and storage.

7