90501515 JS650L 4/5/06 10:53 AM Page 4
e)When cutting pipe or conduit ensure that they are free from water, electrical wiring, etc.
WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are:
•lead from
•crystalline silica from bricks and cement and other masonry products, and
•arsenic and chromium from
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to these chemicals: work in a well ventilated area, and work with approved safety equipment, such as those dust masks that are specially designed to filter out microscopic particles.
•Avoid prolonged contact with dust from power sanding, sawing, grinding, drilling, and other construction activities. Wear protective clothing and wash exposed areas with soap and water. Allowing dust to get into your mouth, eyes, or lay
on the skin may promote absorption of harmful chemicals.
WARNING: Use of this tool can generate and/or disperse dust, which may cause serious and permanent respiratory or other injury. Always use NIOSH/OSHA approved respiratory protection appropriate for the dust exposure. Direct particles
away from face and body.
CAUTION: Wear appropriate hearing protection during use. Under some conditions and duration of use, noise from this product may contribute to hearing loss.
The label on your tool may include the following symbols.
V................voltsA ............amperes
Hz | hertz | W | watts | |||
min | ............minutes | no | alternating current | |||
|
| direct current | no load speed | |||
|
| |||||
|
| ............Class II Construction |
|
| .......... | earthing terminal |
|
|
|
|
| ||
|
|
|
|
| ||
| .............. | safety alert symbol | .../min | revolutions or | ||
|
|
|
|
|
| reciprocations per minute |
mW | ............milliwatts | nm | wavelength in nanometers | |||
II | Class II Laser |
|
|
|
| |
SAFETY INSTRUCTIONS - LASERS
DANGER: Laser Radiation, avoid direct eye exposure, serious eye injury can result.
•Do not use optical tools such as a telescope or transit to view the laser beam.
•Position the laser so unintentional eye contact will be avoided.
•Do not operate the laser around children or allow children to operate the laser.
•Do not disassemble. Modifying the product in any way can increase the risk of laser radiation.
WARNING: Use of controls or adjustments or performance of procedures other than those specified in this manual may result in hazardous laser radiation exposure.
•Do not adjust the laser on the saw unit, when the saw is plugged in.
•Do not operate in explosive atmospheres, such as in the presence of flammable liquids, gases, or dust.
•Use only with the specifically designated batteries in laser. Use of any other batteries may create a risk of fire.
•Store idle product out of reach of children and other untrained persons. Lasers are dangerous in the hands of untrained users.
•Use only accessories that are recommended by the manufacturer for your model. Accessories that may be suitable for one laser, may create a risk of injury when used on another laser.
•Repairs and servicing MUST be performed by a qualified repair facility. Repairs performed by unqualified personnel could result in serious injury.
•Do not remove or deface warning labels. Removing labels increases the risk of exposure to radiation.
•For indoor use only.
•This product is intended for use in a temperature range of 41°F(5°C) - 104°F(40°C).
4
