Black & Decker Marine Battery Care and Maintenance, Accessories, Service Information

90550750 VEC049DCB GOOD ONE.qxp 6/5/09 1:46 PM Page 12

CARE AND MAINTENANCE

Storage

1.Ideal storage temperature range is 50-68°F (10-20°C).

2.Store and use the inverter in a cool, dry place with adequate ventilation.

3.Avoid locations that are exposed to heating units, radiators, direct sunlight or excessive humidity or dampness.

Fuse Replacement

This inverter is equipped with multiple internal fuses. Normally, these fuses will not “blow” unless there is a serious problem inside the unit. Internal fuses are replaceable; however, only trained personnel should attempt fuse replacement. Refer to the “Service Information” section of this Instruction Manual.

Preventive Maintenance

Inverters require minimal maintenance. For optimum performance, the manufacturer recomments periodically performing the following preventive maintenance.

1.Turn OFF the inverter using the front panel ON/OFF Power Switch. 2.Remove the DC power fuse.

3.Check and tighten all electrical connections, including the ground.

4.Using a non-metallic vacuum cleaner hose, vacuum the air slots and fan area. 5.Clean the outside of the unit using a damp (not wet) cloth.

6.Wipe unit surfaces thoroughly with a dry cloth. 7.Re-insert the fuse and resume operation.

ACCESSORIES

Recommended accessories for use with your tool are available from your local dealer or authorized service center. If you need assistance regarding accessories, please call: 1-800-544-6986.

WARNING: The use of any accessory not recommended for use with this tool could be hazardous.

SERVICE INFORMATION

All Black & Decker Service Centers are staffed with trained personnel to provide customers with efficient and reliable power tool service. Whether you need technical advice, repair, or genuine factory replacement parts, contact the Black & Decker location nearest you. To find your local service location, refer to the yellow page directory under "Tools—Electric" or call: 1-800-544-6986or visit www.blackanddecker.com.

CAUTION: TO AVOID PERSONAL INJURY OR PROPERTY DAMAGE:

If the cord becomes damaged, return the entire unit to manufacturer immediately for service/repair.

FULL TWO-YEAR HOME USE WARRANTY

Black & Decker (U.S.) Inc. warrants this product for two years against any defects in material or workmanship. The defective product will be replaced or repaired at no charge in either of two ways.

The first, which will result in exchanges only, is to return the product to the retailer from whom it was purchased (provided that the store is a participating retailer). Returns should be made within the time period of the retailer’s policy for exchanges (usually 30 to 90 days after the sale). Proof of purchase may be required. Please check with the retailer for their specific return policy regarding returns that are beyond the time set for exchanges.

The second option is to take or send the product (prepaid) to a Black & Decker owned or authorized Service Center for repair or replacement at our option. Proof of purchase may be required. Black & Decker owned and authorized Service Centers are listed under "Tools-Electric" in the yellow pages of the phone directory and on our website www.blackanddecker.com.

This warranty does not apply to accessories. This warranty gives you specific legal rights and you may have other rights which vary from state to state or province to province. Should you have any questions, contact the manager of your nearest Black & Decker Service Center. This product is not intended for commercial use.

FREE WARNING LABEL REPLACEMENT: If your warning labels become illegible or are missing, call 1-800-544- 6986 for a free replacement.

SPECIFICATIONS

Maximum continuous power:	1000 watts
Surge capacity (peak power):	2000 watts
Output voltage range:	105-125 volts
Output frequency:	58-62 Hz
Output voltage:	120 VAC
Maximum efficiency:	> 87%
Full load efficiency:	> 82%
No load current draw:	>0.5 amp
Over voltage shutdown:	15.5 ± 0.5 volts DC
Low voltage shutdown:	10.0 ± 0.3 volts DC
Thermal shutdown auto reset:	Yes
North American standard outlets:	2
ANL fuse rating for direct hardwire:	200
Proper cable gauge (AWG) @ 6 ft.	#2X2

Imported by

Black & Decker (U.S.) Inc., 701 E. Joppa Rd. Towson, MD 21286 U.S.A.

See ‘Tools-Electric’

– Yellow Pages –

for Service & Sales

12 13