Black & Decker PHV1810, PHV1210 Maintenance, Troubleshooting, Replacing the filters, Accessories

90560176 PHV1210 PHV1810.qxd:??????-00 Cir Saw book		1/18/10	9:49 AM	Page 6
• The dust container (11) is attached to	G			J	K
the body of the appliance with a bayonet
fixing. To remove the dust container, press
the dust container release button (2) and
rotate the dust container (11)
counterclockwise and carefully slide the
dust container clear of the appliance.
• Rotate the filter hook (12) to the vertical
position (fig. I).
• Use the filter hook (12) to rotate the filter
(13) within the pre-filter (14) to agitate it
and remove dirt.
• Remove the main filter (13).
• Brush any loose dust off the filter (13).
• The pre-filter (14) is attached with a
bayonet fixing. To remove the pre-filter,
rotate the pre-filter (14) counterclockwise
and carefully slide it clear of the dust				Maintenance
container.	H			Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the
• The dust container can be cleaned.
				tool; never immerse any part of the tool into a liquid.
Wipe with a damp cloth or rinse with				IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and
warm soapy water and allow to dry.
				adjustment (other than those listed in this manual) should be performed by authorized
• The filters are re-usable and should be				service centers or other qualified service personnel, always using identical replacement parts.
cleaned regularly. Rinse with warm
soapy water and allow to dry.					Troubleshooting
• Install the pre- filter (14) into the dust
container (11) rotating it clockwise until it				Problem	Possible Cause	Possible Solution
locks into place.				• Unit will not start.	• Battery not charged.	• Check battery charging
• Install the main filter (13) into the
						requirements.
pre-filter (14).				• Battery will not charge.	• Charger not plugged in.	• Plug charger into a working
• Install the dust container (11) to the
						outlet. Refer to “Important
appliance, rotate it clockwise until it locks						Charging Notes” for more details.
into place.						• Check current at receptacle by
						plugging in a lamp or other appliance.

			• Check to see if receptacle is
WARNING:			connected to a light switch which
			the lights.
			turns power off when you turn out
Projectile/Respiratory Hazard: Never use the appliance without the filters. Optimum		• Surrounding air	• Move charger and tool to a
		temperature too hot or	surrounding air temperature
dust collection will only be achieved with clean filters.		too cold.	of above 40 degrees F(4.5°C) or
Replacing the filters	I		below 105 degrees F (+40.5°C).
		For assistance with your product, visit our website www.blackanddecker.com for the
The filters should be replaced every		location of the service center nearest you or call the BLACK & DECKER help line at
6 to 9 months and whenever worn or		1-800-544-6986.
damaged. Replacement filters are
available from your Black & Decker dealer		Accessories
(cat. no. PVF110):		Recommended accessories for use with your tool are available from your local dealer or
• Remove the old filters as described
		authorized service center. If you need assistance regarding accessories, please call:
above.		1-800-544-6986.
• Fit the new filters as described above.
		WARNING: The use of any accessory not recommended for use with
		this tool could be hazardous.

6 7