90560176 PHV1210
Product Features
1. Dust collector
2. Dust container release button
3. Pivot lock button
4. On/off switch
5. Container door
6. Container door release latch
7. Charger
8.
9. Dust collector extension
Use
•Before first use, the battery must be charged for at least 24 hours.
•Plug the appliance into the charger whenever power gets low.
Charging the battery (fig. D) | D |
• Make sure that the appliance is switched | |
off. The battery will not be charged with |
|
the on/off switch (4) in the on position. |
|
• Plug the appliance into the charger (7) |
|
as shown. The charging indicator wil be lit. |
|
• Leave the appliance on charge for at |
|
least 24 hours. |
|
While charging, the charger may become |
|
warm. This is normal and does not |
|
indicate a problem. The appliance can be |
|
left connected to the charger indefinitely. |
|
The charging indicator will be lit as long as |
|
the appliance is connected to the |
|
| |
|
|
Assembly
Adjusting the dust collector
A |
WARNING: Do not charge the battery at ambient temperatures below 39°F (4°C) or above 104°F (40°C).
(fig. A - C)
The dust collector (1) has a brush that can be folded forward for dusting and upholstery cleaning.
•The dust collector (1) is stored under the appliance. To adjust for use, unplug the appliance from the charger (7).
•Press the pivot lock button (3) and rotate the dust collector (1) to the required position.
•Release the pivot lock button (3) to lock the dust collector in position
•The dust collector can be extended by pulling the dust collector extension (9) until it locks into position.
•The extension can be retracted by pressing the button (10) and pushing the extension back into the dust collector.
•The dust collector should be returned to the storage position under the appliance after use and while charging the appliance.
B |
Switching on and off (fig. E)
•To switch the appliance on, slide the on/off switch (4) forward to position I.
•To switch the appliance off, slide the on/off switch (4) back to position 0.
Optimizing the suction force
Rotating the bowl (fig. A) agitates the filter to remove dirt; however, in order to keep the suction force optimized, the dust container and filters must be cleaned regularly.
Cleaning the dust container and filters (fig. F - K)
There are two methods of cleaning the bowl, a quick empty method and a thorough clean method.
E |
F |
C |
For the quick empty method use the following instructions.
•Press the release latch (6) and open the container door (5) (fig. F).
•Empty the dust container (11).
•Close the dust container door (5). Make sure that the release latch (6) clicks into place.
For the thorough clean method use the following instructions.
4 | 5 | ||
|
|
|
|
|
|
|
|
|
|
|
|
