(J)and fill with detergent.
2.) Replace top.
3.) Insert gun wand (H) into detergent applicator (J) until it clicks firmly into place as shown in Figure F.
F
4.The cap on the top of the applicator determines the amount of detergent that is applied. Twist the cap towards the (+) symbol to increase the amount of detergent and toward the
5.) Apply detergent from the bottom to the top to prevent detergent from sliding down and streaking.
6.) Leave detergent on the surface for a few minutes but do not allow it to begin to dry.
7.) Remove detergent applicator from the gun wand by pressing down on the lever as shown in Figure G and pulling the nozzle straight out.
8.) Rinse detergent from surface.
9.) Flush detergent applicator with clean water.
G
NOTE: DO NOT USE:
•Bleach, chlorine products and other corrosive chemicals.
•Liquids containing solvents (i.e., paint thinners, gasoline, oils)
•
•Ammonia products
•
These chemicals will harm the unit and will damage the surface being cleaned.
•ROTATING BRUSH
1.) Insert the rotating brush (F) into the gun wand (H) by pushing and rotating until the two parts are locked as shown in Figure H.
H
2.) Run unit to spin brush for cleaning.
3.) To remove, press brush wand into gun wand and twist.
•FIXED BRUSH
1.) Insert the fixed brush (G) into the gun wand (H) by pushing and rotating until the two parts are locked as shown in Figure I.
I
2.) Run to disperse water while cleaning.
3.) To remove, press brush wand into gun wand and twist.
SURFACE PREPARATION
Before starting any cleaning task it is important to inspect the area for objects which could create a hazard. Remove objects from the area which could be tripped over such as childrens toys or outdoor furniture. Insure that all doors and windows are closed tight. Also make sure that all plants and trees in the adjacent area are protected by a drop cloth ensuring that they will not be harmed by any over spray.
7
