desired band. There are 5 available bands (AM/FM/TV1/TV2/Weather).
4.Rotate the Tuning Knob (3) to select the desired station.
5.Extend the Antenna (18) and rotate in the direction of the best reception for FM/TV1/TV2/Weather. For AM, try to rotate the unit instead.
6.Adjust the On/Off Volume Control (2) to desired sound level.
B. Radio Operation Using AC Adaptor
1.Insert the plug of AC Adaptor (19) into the External AC15V Jack (13) as shown in figure A and plug the AC Adaptor into 120Vac 60Hz electrical outlet.
2.Follow the procedure of “Radio Operation Using Rechargeable Battery”.
C. Radio Operation Using Backup Battery
1.Remove the battery compartment cover (17) as shown in figure C.
C
2.Insert four fresh AA alkaline batteries making sure to match (+) and
3.Switch off the Main Power Switch (12).
4.Follow the procedure of “Radio Operation Using Rechargeable Battery”.
5.The maximum output sound level will be less than when using the rechargeable main battery or AC adaptor as the power supply.
WARNING: Batteries can explode, or leak, and can cause injury or fire. To reduce this risk:
•Carefully follow all instructions and warnings on the battery label and package.
•Do not short battery terminals.
•Do not charge batteries.
•Remove dead battery immediately and dispose of per local codes.
•Do not dispose of batteries in fire.
•Keep batteries out of reach of children.
•Do not mix old and new batteries.
•Replace all of them at the same time with new batteries of the same brand and type.
•Remove battery if the device will not be used for several months.
Transporting batteries can possibly cause fires if the battery terminals inadvertently come in contact with conductive materials such as keys, coins, hand tools and the like. The US Department of Transportation Hazardous Material Regulations (HMR) actually prohibit transporting batteries in commerce or on airplanes (i.e. packed in suitcases and carryon luggage) UNLESS they are properly protected from short circuits. So when transporting individual batteries, make sure that the battery terminals are protected and well insulated from materials that could contact them and cause a short circuit.
LIGHT OPERATION
A. Room Light
1.Switch the Main Power Switch (12) to the ON (I) position.
2.Turn the Room Light on or off by pressing the Room Light On/Off Switch (6).
B. Find Me Light
Three LED’s act as “Find Me Lights” which come on automatically in the event of a power failure. Note: The AC Power Adaptor must be plugged into a 120V outlet.
1.Switch the Main Power Switch (12) to the ON (I) position.
2.When the AC adaptor is plugged in and the AC power fails, the three LED’s will turn on automatically for the purpose of emergency light.
3.The Find Me Lights will turn off when
the Room Light is turned on. The Find Me Lights will also turn off when there is no 120vac power AND the a/c adaptor (19) is removed from the Storm Station.
C. Flashlight
1.Remove the flashlight from the Storm Station.
2.Turn the flashlight on and off by pressing the Flashlight On/Off Switch (16).
3.Rotate the lamp housing of the flash- light to concentrate the focus of the light.
POWER OUTPUT OPERATION
The output of the 12Vdc outlet (14) and Inverter outlet (15) do not function when the AC adaptor (19) is plugged in. Make sure the AC Adaptor is unplugged before operation of the 12Vdc Outlet / Inverter.
8
