Black & Decker VC3200 manual Using Cleaning Tool

USING CLEANING TOOL

Brush and Crevice Tool

1. The 2-in-1 cleaning tool converts from a crevice tool to a brush.

2. Turn the upper part of the cleaning tool in the direction of the arrow to use the brush (N).

N

3. Turn it in the opposite direction and convert the brush back to a crevice tool (P).

Helpful Tips

• Use brush to dust furniture, draperies, lamps and shelves.

P • Use crevice tool for tight narrow spaces.

The cleaning tool can be attached to either the end of the expandable telescopic

S

T

To replace HEPA filter

3.Grasp HEPA filter, turn it counterclockwise (UNLOCK ) and pull out (S).

4.Grip HEPA filter tabs and pull out filter screen (T).

5.Clean HEPA filter and filter screen using a small brush. If needed, wash with mild soap and rinse with cold tap water. Do not use any abrasive cleaners.

6.Shake excess water from HEPA filter and let it dry completely before inserting back into the unit. Also dry protective filter screen.

chrome wand or the flexible hose.

Care and Cleaning

This appliance contains no user-serviceable parts. Refer service to qualified service personnel.

Important: Always turn off and unplug the unit before cleaning any parts.

CLEANING

Note: To maintain maximum cleaning performance, empty the dust collector and clean or replace the HEPA filter screen, HEPA filter, dust filter and exhaust filter often.

Dust Collector

1. To remove dust collector, press release button on the handle and lift up (Q).

2. Remove lid and empty the dust collector.

3. Wash in warm sudsy water with mild detergent.

4. Dry completely with a soft cloth.

Q

HEPA Filter

The HEPA filter is located under the dust collector lid inside the HEPA filter screen.

To remove HEPA filter

1.Turn dust collector upside down.

2.Press the dust collector bottom lid release button and lift

the lid (R).

R

1. Turn dust collector right side up and close the bottom lid.

2.Grasp HEPA filter with the tabs facing up and insert the filter screen with the arrows facing down until it snaps

into place (U).

U

3.Align the notches on the dust collector cover with the tabs on HEPA filter and twist clockwise until it snaps into

place (V).

V
	4.	Align the notches on the dust collector cover with the
		tabs on the dust collector. The opening for the connector
		end on the dust collector cover needs to be on the right
		side of the carry handle for the dust collector. Turn the
		dust collector cover clockwise until it is secure in place
		(W).
W	5.	Insert dust collector back in canister compartment.

6. Close the dust collector compartment cover.

Tip: Pull on the handle to verify that it is secured in place.

19 20