SERVSWITCH™ BRAND FIBER KVM EXTENDER II AND II-SM
Make a last pair of attachments to the connectors on the Remote Unit’s rear panel:
•Attach the male SC male connectors at the Remote-Unit end of your duplex fiber cabling to the Remote Unit’s SC female connectors. (The Extender’s SC connectors are keyed so that you can’t plug the fiber cable in the wrong way.)
•Plug the output cord of the Extender’s second included power supply into the 2.1-mm barrel jack on the Remote Unit’s rear panel. Attach the outlet end of the power supply’s input cord to the IEC 320 male inlet on the transformer. Plug the other end of the input cord into a working AC outlet. The Local Unit should power up immediately—it has no ON/OFF switch. The green Status LED on its front panel should begin flashing to show that it isn’t getting a video signal from the Local Unit yet.
| | CAUTION! |
Do not attach anything to | the | 8-pin mini-DIN connector labeled |
“Service” on the Local Unit’s | rear panel, which is reserved for |
manufacturer use. Doing so could | severely damage the Extender and |
any attached equipment! | | |
