Black Box Black Box Feed-Through CAT6A Patch Panels, C6AFP70S-48, C6AFP70S-24 Installation

Installation

Use the Feed-Through CAT6A Patch Panels with or without the cable management bar. The bar neatly organizes and supports the cables that are installed in the rear of the patch panel.

Find an empty rack space on a relay rack or communications cabinet.

Without using the cable management bar:

1.Install the panel with the supplied 10-32 or 12-24 cuphead screws.

2.Install the RJ-45 patch cables on the front and rear connectors to make the connections.

3.Secure the ground wire to a relay rack or cabinet.

Using the cable management bar:

1.Remove the two cuphead screws from the rear of the patch panel.

2.Position the cable management bar on the patch panel and reinstall the two cuphead screws.

3.Install a patch cable in one of the panel’s rear ports. Unscrew the corresponding silver clip behind the installed port and position the patch cable under the silver bracket. Tighten the screw.

4.For a 48-port patch panel (C6AFP70S-48), repeat Steps 1 through 3 to install the second cable management bar.

5.Secure the ground wire to a relay rack or cabinet.

Installation is complete.

© Copyright 2013. Black Box Corporation. All rights reserved. Printed in U.S.A. Black Box® and the Double Diamond logo are registered trademarks of BB Technologies, Inc. Any third-party trademarks appearing in this manual are acknowledged to be the property of their respective owners.

C6AFP70S-24, version 1

FREE, live, 24/7 Tech Support is just 30 seconds away.

724-746-5500 blackbox.com