Chapter 5: Connection
5. Connection
TP Port and Cable Installation:
1.The switch’s TP ports support
2.Use CAT5 or higher grade
3.Repeat the above steps, as needed, for each
For successful installation and good performance, follow the cabling requirements. Using cables with a lower specification than recommended will negatively impact network performance. For Fast Ethernet TP network connection, you must use CAT5 or higher cables that are up to 328 feet (100 meters) long. For Gigabit TP network connections, you must use CAT5e or higher cables that are up to 328 feet (100 meters) long.
Power On:
Power this switch from PoE PSE (Power Source Equipment) or from external DC power adapter. When connecting a PoE PSE, make sure that your PSE complies with 802.3af or 48 VDC 15.4 W.
After the power is on, all LED indicators will light immediately. Then all LEDs will turn off, except for the power LED, which stays on.
Page 5 |