724-746-5500 | blackbox.com
724-746-5500 | blackbox.com Page 7
Quick Setup GuideQuick Setup Guide
This section briefly describes how to install your ServSwitch CWDM Mux system. Unless you are an experienced user,
we recommend that you follow the full procedures described in the rest of this manual.
Install system
1. Install the ServSwitch CWDM Mux transceivers in the local and remote units. Each wavelength must not
appear more than once in the system. Device pairs must carry transceivers with the same wavelength.
2. Connect interconnection cables from remote/local unit to the ServSwitch CWDM Mux—make sure you
connect the transceivers to the matching port of the ServSwitch CWDM Mux. Be sure to use single-mode
fiber cable between the local and remote units via the common link.
3. Power on the system.
Link established?
Check the fiber cables and fiber connectors.
Check whether the transceivers are plugged
into the correct ports. 1530-µm lightwave trans-
ceivers should plug into 1530-µm ports,
1550-µm transceivers should plug into 1550-µm
ports, and so on.
Done
NO
YES