Zenoah BCZ2500SW, BCZ2500SU Set up, SE10 SE11, Installing Cutting Head SE10, Balance Unit,  15 

6. Set up

SE10

SE11

■INSTALLING CUTTING HEAD (SE10)

1.While locking the gear shaft, by inserting the supplied tool into the upper holder on the gear box, loosen and remove the hexagon nut(left- handed)

2.Fit the holder attached to the upper holder. Then screw in the cutting head to the gear shaft over the holders. Hand-tighten it securely.

■BALANCE UNIT

1.Put on strap and attach unit to strap.

2.Slide clamp up or down until unit balances with head just touching on the ground. (SE11)

15 