6. Set up (BCZ2500S, BCZ2500SU) | |||
SE1 | ■ MOUNTING ENGINE (SE1) | ||
1. | Push the driveshaft housing toward the clutch | ||
| |||
|
| housing and rotate it by hand to check that the | |
|
| driveshaft is engaged with the gears. | |
| 2. | Insert the driveshaft housing into the clutch | |
|
| housing until it bottoms, and align the positioning | |
|
| holes on the clutch housing and the shaft tube | |
|
| and install the screw. When difficult to engage, | |
|
| twist the engine slightly. | |
| 3. | Fasten the clamp securely with two screws. | |
SE2 |
|
| |
IMPORTANT
Tighten the screws gradually by turns.
■CONNECTING THROTTLE WIRE
1. Remove the air cleaner cover.
2. Connect the end of the throttle wire to the joint on the top of the carburetor. (SE2)
SE3 |
(1) |
SE4 |
(1) |
(2) |
(3) |
■CONNECTING SWITCH WIRES
•Connect the switch wires between the engine and the main unit. Pair the wires of the same color.
■INSTALLING HANDLE
•Mount the handle to the shaft tube and clamp it at a location that is comfortable to you. (SE3)
(1) About 19 inches (48cm)
■INSTALLING DEBRIS GUARD
•Put the debris guard on the gear box, attach it with the 4 screws and hardware provided. (SE4)
(1)debris guard
(2)plate
(3)screw
