Installation Instructions
Step 6: Cable arms: Attach the two cable management arms using three 11⁄2" clevis pins.
NOTE: You can install cable management on the opposite side.
(3) clevis pins and cotter pins
(pins install from bottom)
(2) arms 
(identical)
Figure 5. Attaching the cable arms.
Step 7: Monitor attachment. See Figure 6.
Step 7A: Turn the monitor face down on a large flat surface.
Step 7B: Locate the four VESA mounting holes on the rear of the monitor.
Step 7C: Determine if spacers are required. Some monitors have a “recess” on the rear of the monitor. Spacers are provided to fill this gap. See Table 1 for spacer length options.
Step 7D: Determine the screw length. Only use the metric M4 screws provided. Screw length is determined by the spacers used. See Table 1.
| Page 5 | |
|
