Acoustic Alarm
When leaving the coverage area of the tuned in traffic station, your car radio automatically sends out an acoustic alarm after approxima- tely 30 seconds.
This alarm tone can also be heard when pressing a preset button with no ARI station allocated to it.
For switching off the acoustic alarm,
•search for a new station (see chapter “Tuning in a Station Automatically”). The set will then start searching for the next traffic station.
Automatic Start of the Station
Seek Operation (Tape Playback)
When leaving the coverage area of the tuned in traffic station, your car radio will automati- cally start searching for a new traffic station while you are listening to your tape.
Adjusting the Volume of Traffic
Messages and the Acoustic
Alarm
This volume has been set ex factory. Howe- ver, you can adapt it according to your perso- nal preferences.
•Tune in to a traffic information station (“SK”; is displayed).
Activate the ARI function by
•presdsing the ARI rocker switch @.
•Turn the volume down.
Using a suitable screwdriver (maximum bla- de width 2 mm), you can carefully (!) adjust the volume while a traffic message is broad- cast (fig. 2).
For this, the set has to be connected and pulled out of the installation compartment.
Tape Section
Inserting a Tape
If you want to listen to a tape:
•Switch on the set.
•Insert the cassette into the slot with the tape side showing to the right and the empty reel to the front.
Fast Forwarding the Tape
Fast Forward Operation
•Briefly press the FF button 6.
Stopping Fast Forward Operation
•Briefly press the FF button 6.
Removing the Tape
To stop tape play:
•Press the 
button 6 firmly. The cassette is ejected.
19
DEUTSCH
PORTUGUES ESPAGÑOL SVENSKA NEDERLAND ITALIANO FRANÇAIS
