Blaupunkt CR 47 operating instructions Instructions General Operation

Instructions – General Operation

See Traffic Safety and Precautions on page 19.

“Press”means a momentary press of less than 1/2 second. All presses requiring more than 1/2 second are followed by beep.

“Time Out”When additional button presses are anticipated to complete a procedure, the unit will automatically exit the procedure after 4 seconds of inactivity.

Clock Recall

Vehicle ignition must be on. The display switches to clock.

Ignition-On / Turning Unit Off

Press the ON Button to turn the unit off.

Release for Detachable Faceplate

Push REL to detach face. Already inserted cassette remains in unit. Current settings and source mode are stored. If power was not switched off before face removed, unit will automatically power-on when face is reattached.

Power On/Off

When ignition on, press ON or insert a disc to turn unit on. Last-used source becomes active, unless unit is turned on by inserting tape, in which case tape player becomes active.

Power Off

Press ON to turn unit off. Unit stores current settings for source, station or track, etc. Antenna/ amplifier trigger wire shuts off voltage. (If faceplate still attached, display switches to clock.)

Setting the Clock

Turn the unit on. Press the CLK Button for four seconds until the clock starts blinking. (The display will change after two seconds. Ignore this and continue to hold for two more seconds.) Once the clock starts blinking, Press the to set the hour, and press the Button to set the minutes. (To change the minute indicator to the nearest hour (:00), you can press the AUDIO Button. Press the CLK Button again to activate the clock.

Changing the Information Displayed

You can temporarily change the information shown in your unit’s display. You can also select which information has “display priority” and is shown in the display except for moments when adjustments are made.

•To change the display priority, press the DISP Button for two seconds. The display priority changes. The display priority choices are clock or radio frequency/“TAPE”.

•To change the display temporarily, press and release the DISP Button to access the desired information. After four seconds, the display changes back to the priority information.

Source (SRC)

Use SRC to select source - AMT, FM1, FM2, FMT or cassete (if already inserted).

DEUTSCH

ENGLISH

FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL PORTUGUÊS

27