Instructions – General Operation
See Traffic Safety and Precautions on page 19.
“Press”means a momentary press of less than 1/2 second. All presses requiring more than 1/2 second are followed by beep.
“Time Out”When additional button presses are anticipated to complete a procedure, the unit will automatically exit the procedure after 4 seconds of inactivity.
Clock Recall
Vehicle ignition must be on. The display switches to clock.
Release for Detachable Faceplate
Push REL to detach face. Already inserted cassette remains in unit. Current settings and source mode are stored. If power was not switched off before face removed, unit will automatically
Power On
When ignition on, press ON or insert a disc to turn unit on.
Power Off
Press ON for more than 1/2 second to turn the unit off. Unit stores current settings for source, station or track, etc.
Setting the Clock
Turn the unit on. Press the CLK Button for four seconds until the clock starts blinking. (The display will change after two seconds. Ignore this and continue to hold for two more seconds.) Once the clock starts blinking, Press the 
to set the hour, and press the 
Button to set the minutes. Press the CLK Button again to activate the clock.
Changing the Information Displayed
You can temporarily change the information shown in your unit’s display. You can also select which information has “display priority” and is shown in the display except for moments when adjustments are made.
•To change the display priority, press the DISP Button for two seconds. The display priority changes. The display priority choices are clock or radio frequency/“TAPE”.
•To change the display temporarily, press and release the DISP Button to access the desired information. After four seconds, the display changes back to the priority information.
Source
Use SRC to select source - AMT, FM1, FM2, FMT, cassete (if already inserted) or external unit (“InP” display).
DEUTSCH
ENGLISH
FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL PORTUGUÊS
27
