7lo.m

lo - to select the seek tuning sensitivity level

m - manual tuning

“lo” is displayed - normal seek tuning sensitivity

“lo” is off - high seek tuning sensitivity “m” is displayed - manual tuning with / .

Press lo.m several times if required to select the desired funtion.

8AUD/LD AUD – audio

To adjust the treble, bass, balance and fader.

Adjusting the fader is not possible with the Caracas RCR 27.

If the display shows “TREB” or “BASS”, you can adjust the playback of the treble and bass frequencies using the rocker switch.

If “BAL” or “FAD” is displayed, you can set the balance (left/right) and fader (front/rear).

Press AUD/LD as many times as re- quired and make the setting using the rocker switch.

The last setting will be stored automa- tically.

To switch off AUD: Press button once again.

If you do not change the setting within 8 seconds, the display will switch back to the previous condition.

LD - Loudness

When the system is played at a low vo- lume level, the Loudness function creates a more natural sound by boosting the low frequency range.

Loudness on/off:

Press AUD/LD for approximately 1 sec.

“LD” lights up in the display, if the Loudness function is switched on.

9BND/TS

BND - To select the wavebands FM, MW (M) and LW (L) as well as the FM memory banks I, II and T.

To switch over:

Press BND as often as required. The selected mode appears in the display.

TS - Travelstore

To store and recall the five most powerful stations with Travelstore. To store: Press button for approxi- mately 1 sec. until you hear a beep and “T-STORE” appears in the display. To recall: Select the memory bank “T” and press the corresponding preset button (1 - 5) briefly.

PORTUGUÊS ESPAÑOL SVENSKA NEDERLANDS ITALIANO FRANÇAIS ENGLISH DEUTSCH

17

Page 5
Image 5
Blaupunkt RCR 27, RCR 87 operating instructions Lo.m, AUD/LD AUD audio, Loudness on/off, To switch over