Blaupunkt VA4100 manual Connections & Controls

Models: VA4100

1 14
Download 14 pages 27.8 Kb
Page 8
Image 8
CONNECTIONS & CONTROLS

CONNECTIONS & CONTROLS

REMOTE GAIN

FRONT

REAR

LINE LEVEL

CONTROL JACK

CROSSOVER

CROSSOVER

INPUTS

 

SELECTOR,

SELECTOR,

 

 

CROSSOVER

CROSSOVER

 

 

MODE SELECTOR

MODE SELECTOR

 

 

& GAIN CONTROL

& GAIN CONTROL

 

REMOTE GAIN CONTROL JACK - For connecting the remote gain control (included). This allows you to adjust the gain while seated in the vehicle with the system operating.

FRONT & REAR CHANNEL CONTROLS

GAIN CONTROL - The gain control allows for a range of 0.3-6Volts input. This means that if the setting is a 0.3V, it only takes 0.3Volts to drive the amp to full output. (Such a low setting allows for the amp to be easily overdriven and more susceptible to noise so a mid-position is highly recommended for most radios.)

CROSSOVER MODE SELECTOR - Depending upon the system design chosen, you need to set the amplifier in the proper “mode”; LP, Flat, or HP. The low-pass and high-pass frequency settings are explained below. The “Flat” setting simply allows for the amp to pass all audio frequencies without any kind of crossover filter application. (This is common with 6x9” fullrange coaxial speakers for example.)

CROSSOVER CONTROL

HIGH-PASS - If the Mode Selector is in the “HP” position the amplifier passes only mid and high frequency sound. The lower limit for such sound is set via this control. A common setting is just above 100Hz.

LOW-PASS - If the Mode Selector is in the “LP” position the amplifier passes only low frequency sound. The upper limit for such sound is set via this control. For bass, a value just below 100Hz is usually best.

LINE LEVEL INPUTS - The most commonly used inputs in the aftermarket are RCA type line level inputs. These can handle up to about 6 Volts rms without overdriving the amplifier. Such high voltages are rarely found from car audio head units so this is a very comfortable value. But, should the use need to drive the amp directly from speaker level leads, use the supplied “High Level Adapter” to connect to the amp.

– 7 –

www.midwestelectronics.com

Page 8
Image 8
Blaupunkt VA4100 manual Connections & Controls