PREPARATION
Prior to first use, thoroughly clean warmer (see page 6).
Be sure faucet handle is "up" and that drip tray is in place under faucet.
USE
Pour product into warming tank. Using
Model HD8799 utilizes a fixed thermostat to hold product at 140ºF (60ºC).
Model HD8802 thermostat may be adjusted to hold product at 170ºF (77ºC) maximum.
Reinstall tank cover.
Plug dispenser into an appropriate electrical receptacle. Turn power switch to ON.
When the READY light glows, product is ready to serve: Place an appropriate container under the faucet. Pull the faucet handle to dispense product. Release the handle to stop the flow of product.
NIGHTLY CLOSE
Turn the power switch to OFF and unplug the dispenser. If required, empty the dispenser and clean.
TEMPERATURE ADJUSTMENT (Model HD8802 only)
Remove button plug from rear of dispenser to access thermostat. Turn shaft of thermostat to adjust setpoint temperature. Turn the shaft clockwise to increase temperature. Moving the shaft 1/8 turn will change the temperature approximately 10ºF.
OPERATION
CAUTION:
Burn Hazard
Exposed surfaces of the appliance may be HOT to the touch and can cause burns.
NOTE: Product may continue to flow for several seconds after the faucet is released. Do not remove the container until all flow has stopped.
IMPORTANT: Your local Health Department can advise whether or not a particular product may be left in the dispenser over- night.
IMPORTANT:
Temperature adjustment to be performed by authorized personnel only.
5