Blue Rhino 153300 owner manual Operation, Before Turning Gas Supply on, Before Lighting

Models: 153300

1 42
Download 42 pages 59.33 Kb
Page 14
Image 14

Contact 1-800-762-1142 for assistance.

Do not return to place of purchase.

WARNING

FOR YOUR SAFETY:

If at any time you are unable to light pilot and smell gas, wait 5 minutes to allow gas to dissipate before attempting to light heater.

WARNING

FOR YOUR SAFETY:

Do NOT touch or move heater for at least 45 minutes after use.

Allow all burner elements to cool before touching.

Operation

Caution: Do NOT attempt to operate heater until you have read and understand all precautions in section 1 “Safety First.”

Before Turning Gas Supply ON

Your heater was designed and approved for outdoor use only. Do NOT use it inside a building, garage, or any other enclosed area.

Disconnect the LP source and move the cylinder to a well-ventilated area outdoors, out of the reach of children. The cylinder must not be stored in a building, garage, or any other enclosed area.

Ensure that there is no obstruction to air ventilation.

Be sure all gas connections are tight and there are no leaks.

Be sure the cylinder cover is clear of debris.

Be sure any component removed during assembly or servicing are replaced and fastened prior to starting.

Before Lighting

View Hole

Heater should be thoroughly inspected before each use, and by a qualified service person at least annually.

If relighting a hot heater, always wait at least 5 minutes.

Inspect the hose assembly for evidence of excessive abrasion, cuts, or wear. Suspected areas should be leak tested. If the hose leaks, it must be replaced prior to operation. Only use the replacement hose assembly specified by manufacturer.

Pilot

LOW

(Push in)

 

HIGHOFF

Pilot

LOW

(Push in)

 

HIGHOFF

13

Lighting

Note: This heater is equipped with a Pilot Light that allows for safer startups and shutdowns. Pilot must be lit before Main Burner can be started.

Turn Cylinder Valve OFF.

Push Control Knob IN and turn to OFF.

Wait 5 minutes for any gas to clear.

Turn Cylinder Valve ON.

Open Viewing Hole by sliding cover to either side.

Push Control Knob IN and rotate to Pilot position.

Note - For initial start or after any cylinder change, hold Control Knob IN for 2 minutes to purge air from gas lines before proceeding.

Push Igniter button once. Pilot Light flame will appear and be visible through Viewing Hole.

Release Control Knob after 30 seconds. Pilot Light will remain lit. If not, return to step 1.

Owner’s manual and assembly instructions: model 153300 outdoor patio heater

3/28/03

Page 14
Image 14
Blue Rhino 153300 owner manual Operation, Before Turning Gas Supply on, Before Lighting