Contact
Do not return to place of purchase.
Step 9 – Attach Dome to Emitter
•Line up holes in dome assembly with the studs from the emitter assembly and lay dome assembly in place. Secure with three nuts.
•Place dome cap over center bolt, making sure that the three slots in cap lay over each Rib
•Thread on finial until tight.
Step 10 – Secure Gas Line
•Make sure angled side of Gas Clip pokes up through large hole in Platform.
•Tighten screw until Gas Line is held securely in place.
•Stand Heater upright.
Step 11 – Connect Gas Line to Cylinder
The pressure regulator and hose assembly supplied with the appliance must be used and replacements must be those specified by the manufacturer.
Caution: Before you attempt to use a propane cylinder, understand all cylinder and propane related precautions in Section #1 - “Safety First.”
•Slide full Propane Cylinder onto Heater Base.
•Attach Gas Line to Cylinder by turning black plastic knob clockwise over Cylinder valve until tight.
Note: Be careful not to kink flexible hose of Gas Line.
•Secure cylinder in place by attaching loose end of Cylinder Restraint Chain to hole in left leg.
Owner’s manual and assembly instructions: model 200209 outdoor patio heater | 1/15/03 | 10 |