Operation

Placement

The use and installation of this product must conform to local codes. In absence of local codes, use the National Fuel and Gas Code, ANSI Z223.1/NFPA 54, Storage and Handling of Liquified Petroleum Gases, ANSI/NFPA 58 or CSA B149.1, Natural Gas and Propane Installation Code.

Properly positioning your SkeeterVac® device is important to maximizing performance. Since the SkeeterVac® device attracts mosquitoes it should be placed at least 10 feet from your living areas.

Mosquitoes typically live in areas that are shady, wet and / or moist. Determine the primary mosquito habitat and place your SkeeterVac® device as close as possible to it.

If you live in an area with consistent wind, place your SkeeterVac® device upwind from the primary mosquito habitat.

CAUTION: Tipping danger. Use stakes to secure.

Once you have selected the location, secure the SkeeterVac® device by placing a stake in each of the

(4) stake holes.

Maximum performance may require relocating your SkeeterVac® device from time to time. To move, remove stakes, place your foot on the cart base and tilt backward by holding the handle. Pull to the new location. Re-install stakes.

FineTune®: Customizing the Lure Output

The amount of octenol your SkeeterVac® device dispenses is important to maximizing performance. Some mosquito species are highly attracted to octenol while others are less attracted.

This product contains an easy-to-use feature that allows you to customize the amount of octenol released to match the species in your environment.

1.Remove rain cover by turning counterclockwise2.Remove foil seal from the Biting Insect Lure3.Place lure back into holder with holes orienting upward

4.From the illustrations provided on the engine label, select the environment that best matches the area you are protecting

5.Position the ring so it points to your environment

To Start

1.With the rain cover removed, turn gas ON at LP gas tank by slowly turning valve counterclockwise 2 full turns and be prepared IMMEDIATELY to follow step 2

2.IMMEDIATELY press and hold the red igniter button down until you hear a “POP” sound indicating ignition. Normally occurs within 20 seconds

3.The needle on the engine gauge should begin to move into the green zone, indicating ignition is complete

CAUTION: If needle does not move within 20 seconds after “POP”, shut gas off at tank and wait 3 to 5 minutes before attempting to restart the engine

4. Replace the rain cover

To Turn Off

Turn gas OFF at tank by turning valve clockwise until it stops

CAUTION: The gas supply must be turned off at the LP gas tank when this outdoor gas appliance is not in use.

Model#CPSV002704

Page 6