Normal: Soft blue flames with yellow tips between 1 in. - 2 in. hight.
Needs Cleaning: Noisy with hard blue flames.
Has to be cleaned: Wavy with yellow flames.

Outdoor LP Gas Barbecue Grill Model No. GBC772W

GOLD

Operating Instructions (continued)

Operating Side Burner

Cleaning and Care

Burner Flame Conditions
NOTE: Side burner can be used while main burners are operating.Never use side burner as a grill.

Flame Slight

Yellow

Slight

Caution

1. All cleaning and maintenance should
be done when grill is cool and with

Use this chart check to see if your burners need to be cleaned.

mm

/

Lighting

Burner

Blue

the fuel supply disconnected.

-2 in.

- 50.8

1

25.4

1.

Open lid. Attempting to light the burner with the lid

 

closed may cause an explosion!

2.

Make sure there are no obstructions of airflow to the

 

gas unit. Spiders and insects can nest within and clog

 

the burner / venturi tube at the orifice. A clogged burner

 

tube can lead to a fire beneath the appliance.

3.

Control knob must be in the “OFF” position.

4. Turn on gas at LP-gas supply tank.

5.

Push and turn control knob slowly about 1/4 turn

 

counter clockwise until a click is heard. The burner

 

should light. If the burner does not light, repeat up to

 

three times.

6.

If ignition does not occur, turn control knob to “OFF”,

 

wait 5 minutes and repeat lighting procedure.

Dark

Blue

Side burner proper flame height.
2. DO NOT clean any grill part in a self
cleaning oven. The extreme heat will
damage the finish.
Notices1.This grill should be thoroughly cleaned and inspected on a regular basis.2.Abrasive cleaners will damage this product.3.Never use oven cleaner to clean any part of grill.

4.Do not clean any grill part in a self cleaning oven. The extreme heat will damage the finish.

Before Each Use:

-2 in. /

- 50.8 mm

1

25.4

7. If igniter does not light burner, use a lit match secured

with the lighting rod provided to light burners manually.

Position the lit match near side of the burner.

Important: Always use the lighting rod provided when lighting burners with a match.

8.After lighting, please observe the burner flame, make sure all burner ports are lit and flame height matches illustration.

CAUTION: If burner flame goes out during operation, immediately turn the gas “OFF” and open lid to let the gas clear for about 5 minutes before re-lighting.

Turning Off

1.Turn gas off at LP gas tank.2.Turn control knob clockwise to the “OFF” position.Note: A “poof” sound is normal as the last of the LP gas is burned.

Control Knob

Side Burner Lighting Hook Placement

1.Keep the grill area clean and free from any combustible materials, gasoline, and other flammable vapors and liquids.

2.Do not obstruct the flow of the combustion of LP and

the ventilation air.

3. Keep the ventilation opening(s) of the LP gas tank area free and clear from debris.

4. Visually check the burner flames, to make sure your grill is working properly.

5. See cleaning instructions below for proper cleaning instructions.

6. Check and clean the burner/venturi tubes for insects and insect nests. A clogged tube can lead to a fire beneath the grill.

Cleaning Surfaces1.Wipe surfaces clean with mild dishwashing detergent or baking soda.

2.For stubborn surfaces use a citrus based degreaser and a nylon scrubbing brush.

3.Rinse clean with water.
Cooking1.Light burner.2.Set burner to desired temperature3.Place pan on center of grid.4.Cook and adjust temperature as needed.

Operating Infrared Back Burner

NOTE: Infrared back burner can be used while main burners are operating.

1.Open lid. Attempting to light the burner with the lid closed may cause an explosion!

2.Make sure there are no obstructions of airflow to the gas unit. Spiders and insects can nest within and clog the burner / venturi tube at the orifice. A clogged burner tube can lead to a fire beneath the appliance.

3.Control knob must be in the “OFF” position.4.Turn on gas at LP gas tank.5.Push and turn control knob slowly about 1/4 turn counterclockwise.6.Hold the knob 3 to 5 seconds to allow gas to reach and light the burner.7.Burner should turn red after 2 to 3 minutes.

8.Turn control knob off is burner is not lit. Wait 5 minutes and repeat lighting procedure.

Cleaning Main Burner1.Turn gas off at the control knobs and LP gas tank.2.Remove cooking grid and heat plates.

3.Remove burner by removing the fasteners securing the burner to the grill bottom.

4.Lift burner up and away from gas valve orifice.5.Disconnect wire from spark electrode.6.Clean inlet (venturi) of burner with small bottle brush or compressed air.7.Remove all food residue and dirt on burner surface.8.Clean any clogged ports with a stiff wire (such as an opened paper clip)

9.Inspect burner for any damage (cracks or holes). If damage is found, replace with new burner.

10.Reinstall burner, check to insure that gas valve orifice is correctly positioned inside burner inlet (venturi). Also check position of spark electrode.

11.Replace heat plate and cooking grid.12.Preform leak test.Cleaning Side Burner

1.Turn gas off at the control knobs and LP gas tank.

2.Remove side burner grid.3.Remove burner by removing the screws securing the burner to the side shelf.

4.Lift burner up and away from gas valve orifice.

5.Clean inlet (venturi) of burner with small bottle brush or compressed air.6.Remove all food residue and dirt on burner surface.7.Clean any clogged ports with a stiff wire (such as an opened paper clip)

8.Inspect burner for any damage (cracks or holes). If damage is found, replace with new burner.

9.Reinstall burner, check to insure that gas valve orifice is correctly positioned inside burner inlet (venturi). Also check position of spark electrode.

10.Replace cooking grid.11.Preform leak test.