Contact 1-800-762-1142 for assistance.

Do not return to place of purchase.

Cleaning the main burner assembly

1.Turn gas off at the control knobs and LP cylinder.

2.Remove cooking grates and heat plates.

3.Remove burner by removing the three fasteners securing the burner to the grill bottom.

4.Lift burner up and away from gas valve orifice.

5.Disconnect wire from spark electrode.

6.Clean inlet (venturi) of burner with small bottle brush or compressed air.

7.Remove all food residue and dirt on burner surface.

8.Clean any clogged ports with a stiff wire (such as an opened paper clip)

9.Inspect burner for any damage (cracks or holes). If damage is found, replace with new burner.

10.Reinstall burner, check to insure that gas valve orifices are correctly positioned inside burner inlet (venturi). Also check position of spark electrode.

Cleaning the side burner assembly

1.Turn gas off at the control knobs and LP cylinder.

2.Remove side burner grid.

3.Remove burner by removing the two screws securing the burner to the side shelf.

4.Lift burner up and away from gas valve orifice.

5.Clean inlet (venturi) of burner with small bottle brush or compressed air.

6.Remove all food residue and dirt on burner surface.

7.Clean any clogged ports with a stiff wire (such as an opened paper clip)

8.Inspect burner for any damage (cracks or holes). If damage is found, replace with new burner.

9.Reinstall burner, check to insure that gas valve orifice is correctly positioned inside burner inlet (venturi). Also check position of spark electrode.

Owner’s manual: model NSG4303 outdoor gas grill

1/14/04

28