3Pair Your T1
1. Turn the T1 on by |
| |
sliding the power |
| |
switch on the back to | Power switch (on) | |
the green on position. | ||
|
2.Put the T1 in your ear.
3.The first time you use the T1 it will go straight to pair mode and talk you through the pairing process.
For subsequent pairings, make sure the T1 is not connected to any phones, then hold down the MFB. The T1 will announce that it is going into pairing mode.
Tip: The pairing code is 0000 (four zeros).
4Transfer Your Phonebook
Once the pairing is complete, your T1 will attempt to transfer your phonebook contacts so that it can announce the names of incoming callers. Please accept any connection requests from the T1 and wait for the transfer to finish.
Some phones do not support automatic phonebook transfers. If the T1 announces that this is the case, you need to go to your phone’s address book and send contacts via Bluetooth to the T1. See www.blueantwireless.com for help.
Note: Whenever you add contacts to your phone in future
you must update your phonebook on the T1: with the T1 connected to your phone but not on a call, hold down the MFB for 3 seconds to initiate a phonebook update.
