end) where the elastic cord is exposed.
7.Attach each looped end of the elastic cords (protruding out sides of back flap) around each black shock knob on respective side of stroller, as shown in Fig. 7 (right side shown). The cord locks allow the loop to be enlarged or reduced, thereby adjusting the tension.
8.Locate black plastic end plugs at outboard ends of stroller. Note hole on top of each plug. Locate metal wire stay at front of Weather Shield (see Fig. 8). Pull Weather Shield forward and insert ends of metal stay into holes on the black plastic plugs.
9.Stretch the elastic edges of the Weather Shield and route under sides of stroller frame as shown in Fig. 9.
10.Align vents on rear flap of Weather Shield with air passages between top of seat back and canopy flap. Make sure air opening is not obstructed (Fig. 5).
11.To place child in the stroller, pull the front of the Weather Shield off the front of stroller, then lift up, stretch and roll over the forward edge of stroller canopy as shown in Fig. 10. This will temporarily hold the Weather Shield out of your way while you place the child into the seat.
12.Once your child is secured in the safety harness (refer to your stroller’s Owner’s Manual, Seat Safety Harness section), release the Weather Shield from canopy and
CARE INSTRUCTIONS:
Hand wash cold and hang dry. Do not dry clean, iron, or place in dryer.
Ends of |
metal Stay |
plastic |
Plugs |
with |
holes |
Fig. 8 Front attachment: |
Insert Stay ends into holes. |
Fig. 9 Elastic properly routed under frame sides and ends.
LIMITED WARRANTY:
BOB Trailers Inc. takes pride in its workmanship and strives to manufacture the best products possible. Therefore, we warranty the Weather Shield against defects in material and workmanship subject to the conditions listed below. Since no product is indestructible, it does not cover defects attributable to or resulting from normal wear, abuse or alteration.
.The Weather Shield is warranted for one year from the date of original purchase.
.Warranty is only valid for the original purchaser.
.Proof of purchase is required to exercise this warranty.
.Labor and freight charges are not included.
.Normal wear, neglect, abuse, accidents, improper use are not covered by this warranty.
.Warranty claims must be made through an authorized dealer.
.This warranty is limited to the repair or replacement of the defective part. BOB shall in no event be responsible for consequential or special damages.
.This limited warranty is the only express or implied warranty applicable to BOB. Any implied warranties, including warranties of merchantability and fitness shall be limited in scope and duration in accordance with this limited warranty.
Fig. 10 Shield placed on forward edge of canopy
Fig. 11 Shield correctly installed
OMA23 | BOB Trailers, Inc. 2006 | P2 |
