sport utility stroller Weather Shield instructions
(800)
Congratulations on your purchase of the BOB Weather Shield. It is designed to provide your child with protection from inclement weather. Proper installation and care will provide years of reliable service.
Before attempting to use or attach your new Weather Shield, read and understand these instructions completely to insure proper assembly and operation. If you are unclear on any point, contact your dealer or BOB before use.
Warnings 
.This product is designed exclusively for use with BOB Sport Utility, Sport Utility D’Lux and Ironman strollers. It is not intended for use with other strollers or products.
.The Weather Shield is made of a
.Always make sure all vents are unobstructed, as indicated in Fig.1.
.The Weather Shield is not designed to work with optional Infant Car Seat Adapter and car seat.
.Do not use Weather Shield when temperatures exceed 65oF/18oC. Use in higher temperatures can cause unsafe conditions inside the Weather Shield.
. Never leave child unattended.
. When not in use, keep out of reach of children.
.When the Weather Shield is used, the rear canopy flap must be in correct position as described below. This will insure proper airflow and avoid danger of suffocation.
INSTALLATION INSTRUCTIONS:
1.Set stroller Parking Brake (refer to Parking Brake section of stroller Owner’s Manual). Place sun canopy into position to receive the Weather Shield as shown in Fig.2.
2.Pull each canopy drawstring in order to gather extra material under canopy. Cinch cord lock against canopy to retract and hold material, as shown in Fig. 3.
Very important: when the Weather Shield is used, the rear canopy flap must be in correct position as described below. This will insure proper airflow and avoid danger of suffocation.
3.Locate rear canopy flap and fold forward. Attach canopy flap Velcro on flap to respective Velcro mate on top outboard sides of canopy as shown in Fig. 4. Warning tag on rear canopy flap also describes and illustrates this critical step.
4.Inspect opening at back of stroller to make sure the air passage between top of seat back and canopy are unobstructed (see Fig. 5). We recommend reclining seat back slightly to optimize airflow (refer to Reclining Seat section of stroller Owner’s Manual).
5.Place Weather Shield on the stroller so the rear flap drapes over back (between the handlebars) and the seam above the window is aligned with the forward Sun Canopy supports (see Fig. 6).
6.Stretch the elastic cord on each side under each respective black shock knob as shown in Fig. 7. There is an opening mid way up each side (with silver reflective fabric on each
| Side |
| Vents |
| Front |
Rear | Vent |
| |
Vents |
|
Fig. 1 Vents unobstructed
Rear
Canopy
Flap 
|
|
|
|
| Forward |
Aft Canopy Support |
| Canopy |
Fully Rotated Back |
| Support |
Fig. 2 Canopy Supports in positon.
Cinch Cord Lock tight against Canopy
Fig. 3 Canopy Drawstring
Adjustment
Fig. 4 Canopy Flap in Position
Air Passage
Fig. 5 Rear Vent Unobstructed
| Align |
| seam |
| with |
| forward |
Elastic | canopy |
cord | support |
end |
|
loop |
|
Fig. 6 Shield placed on canopy | |
Loop Around
Black Knob
Elastic Under
Black Knob
Fig. 7 Elastic under knob
OMA23 | P1 |
