Tracking Adjustment
Instructions:
Note: Tracking adjustment can only be performed with the stroller fork locked out (Jog Mode). Roll test the stroller as described below. It is recommended you have someone assist with this task in order to catch and return the stroller. Fig. 12 illustrates the roll test process.
a. Empty the stroller.
Top View Of Stroller | Wheel axles | Stroller pulls | Stroller pulls |
| perpendicular | to right | to left |
90o | to straight line |
|
|
|
|
| |
|
| 16’ |
|
Fig. 12 Stroller roll test. |
|
| |
WARNING: Do not roll test with a child or any occupant in the stroller.
b. Find a location on level ground approximately 16 ft. long. It is helpful to use an existing
c. Align the stroller so the rear wheel axles are perpendicular to the straight line. Push and release the stroller, trying carefully not to influence its direction to the left or right, so it rolls straight down the test path. This step should be performed more than once to make sure the stroller was not biased left or right by the pushing action.
d. If the stroller consistently pulls to the left or right when pushed straight, proceed with the steps below until tracking is satisfactory. Fig. 12 illustrates how to interpret the results.
Reference convention: Left and right are described as viewed from the operator’s
frame of reference (behind the stroller). Example: The swivel lockout knob is on the left side of the stroller.
Tracking |
Adjustment |
Knob |
Fork |
Fig. 13 Tracking Adjustment. |
Fine tune tracking of stroller is accomplished by using the tracking adjustment knob shown in Fig. 13. If your stroller pulls to the left, turn the knob
8. PARKING BRAKE:
The brake is a parking brake, it prevents the stroller from moving while loading and unloading. The parking brake is not designed as a stopping brake.
WARNING: Do not use the brake to slow or stop the stroller because doing so could cause the stroller to stop abruptly, resulting in loss of control.
WARNING: The brake is intended to park the stroller on flat surfaces, not on inclines. Never leave your child in the stroller unattended with or without the parking brake set!
Brake Bar
(Locked Position)
Locking
Pin
(Engaged)
Locking
Disk
Red Foot Pedal
To set the parking brake, press the brake bar down into the locked position (Fig. 14) with your foot on the red foot pedal – making sure the locking pin fully engages the locking disk. To ensure the brake is set properly, attempt to roll the stroller fore and aft after setting the brake. If the stroller will not roll, the brake is set properly. To release the parking brake, lift up on the red foot pedal with your foot until the brake bar springs up into the fully unlocked position (Fig. 15).
9. SUN CANOPY:
The stroller features a two position canopy. To fully open the canopy, rotate the assembly forward until the fabric is taut. The rear canopy flap should be freed from the Velcro to give additional sun protection. To reduce the size of the sun canopy, pull the canopy toward the handlebar. The additional fabric can be gathered by pulling the canopy drawstring (Fig. 1) and securing the cord lock.
10. SEAT SAFETY HARNESS:
WARNING: Set parking brake before placing child in stroller.
To secure your child in the seat, put one shoulder strap over each shoulder and snap the male buckle into the female receiver on the crotch strap (Fig. 16). Adjust shoulder straps to be snug and secure (Fig. 17). Connect the sternum strap (red), see Fig. 18.
Fig. 14 Parking Brake - Locked position.
Brake Bar 
(Unlocked Position)
Fig. 15 Parking Brake - Unlocked position.
WARNING: Never place passengers in the stroller without securing them in the harness. Unrestrained passengers can affect the control of the stroller.
Passenger weight limit - 70 lbs (32 kg) Passenger height limit - 44 in (112 cm)
For heavier and or taller passengers (closer to the maximum limits above), auxiliary harness anchors may be utilized by unfolding anchor Velcro (Fig. 17), sliding ladder lock buckles above anchors, and reconnecting Velcro to keep ladder lock buckles in place.
11. RECLINING SEAT:
WARNING: Set parking brake before making any seat adjustments.
To partially recline the seat, rotate the ladder lock buckles forward thus releasing the reclining straps. (Fig 19)
To fully recline the seat, unfasten side release buckles at seat back. (Fig. 20)
Shoulder |
Strap |
Crotch |
Strap |
Buckle |
Fig. 16 Place straps over shoulders |
and secure to buckle. |
OMS05A | P4 |
