Troubleshooting
PROBLEM | CONDITION | CAUSE | |
|
| • Amplifier not plugged in. | |
| Status LED is off. | • AC outlet dead. | |
| • Power switch off. | ||
|
| • Breaker (power switch) tripped. | |
|
| - Turn off, then turn back on. | |
|
|
| |
NO SOUND | Status LED is green. | • Level controls turned down. | |
| • No signal from source. | ||
| Signal LED is off. | ||
| • Input module jumpers in wrong bus configuration (if available). | ||
|
| ||
|
|
| |
| Status LED is green. | • 70V mono connections on amplifier incorrect. | |
| |||
| Signal LED is green. | • Poor/broken speaker wiring. | |
| Clip/Limit LED is off. | • Defective speakers. | |
|
|
| |
DISTORTED | Status LED is green. | • Input signal level too high. | |
Signal LED is green. | • Poor speaker connections. | ||
SOUND | |||
Clip/Limit LED is off. | • | ||
| |||
|
|
| |
POOR | Status LED is green. | • | |
Signal LED is green. | • Speaker wiring phasing. | ||
RESPONSE | |||
Clip/Limit LED is off. | • Module bass control setting (if available). | ||
(NO BASS) | |||
|
| ||
|
|
| |
|
| • DC level at signal input. | |
INTERMITTENT | Status LED is red/green cycling. | • Load impedance too low. | |
OPERATION | • Amplifier speaker output is | ||
| |||
|
| • Amplifier too hot (check for proper ventilation clearances). | |
|
|
| |
|
| • Poor electrical connections at input. | |
|
| • Input cable routed near AC cables, power transformer, or | |
|
| other EMI radiating devices. | |
NOISE/HUM | Status LED is green. | • Electrically noisy devices operating on the same AC circuit. | |
Signal LED is green. | • Poor equipment grounding. | ||
| |||
|
| - Ensure that all AC safety grounds are connected. | |
|
| - Make sure that all components in audio chain are tied to the | |
|
| same ground. | |
|
|
|
14