OPERATING THE SNOW CAB

17.Assemble two spiral hooks into holes on top of u-tube at front of tubing frame. See figure 9.

18.Insert ends of rope down through spiral hooks attached to u-tube and then insert ends through two grommets in front of canopy. See figure 9.

SPIRAL HOOKS

ROPE

GROMMETS

FIGURE 9

19.Insert one end of rope through a third spiral hook and tie a knot in end of rope. See figure 10.

20.Assemble spiral hook with rope attached through hole in footrest clamp. See figure 10.

21.Insert other end of rope through remaining spiral hook. Tie a knot in end of rope so that when hooked to other footrest clamp the rope is tight and canopy frame is stable. See figure 10.

ROPE MAINTENANCE

SPIRAL HOOK

FOOTREST CLAMP

FIGURE 10

OPERATING THE SNOW CAB

Read this owner's manual and safety rules before operating your tractor with the Snow Cab.

CAUTION: Watch out for low tree limbs and other overhead objects which may interfere with the snow cab.

CAUTION: This cab provides foul weather protection only. It does not provide protection against exhaust fumes, collision, rollover or other accidents.

CAUTION: Never transport the tractor in an open truck or open trailer while the snow cab is attached.

1.Check the area of operation thoroughly before using the tractor with the snow cab. The added height of the snow cab and a reduced field of vision require extra caution during operation.

2.Enter the snow cab on the left side at the rear. Unfasten the elastic hook at the bottom and the velcro fastener in the top in the rear corner.

3.Operate outside controls on a snowthrower or snow blade through the access flaps in the sides of the canopy.

4.Remove the upper snow cab frame and canopy before you transport the tractor in an open truck or open trailer.

MAINTENANCE

1.Before each use make a thorough visual check of the snow cab for any bolts and nuts which may have loosened. Retighten any loose bolts and nuts.

2.The vinyl portion of the canopy can be washed using water only, or a mild liquid soap and water.

3.The plastic windows should only be washed using running water, or a mild liquid soap and water. Wash the windows with your bare hands only. A cloth, sponge or brush will scratch the clear plastic.

IMPORTANT: Never clean the windows when the plastic is dry. The clear plastic will scratch.

4.Clean the vinyl canopy thoroughly and allow to dry before storing. Refer to the Cleaning section.

5 . Store the snow cab in a clean, dry area away from direct sun light.

6

Page 6
Image 6
Bolens 190-751-OEM manual Operating The Snow Cab, Maintenance