SECTION 1: UNPACKING
Extension | Link | |
Rod | ||
Spring | ||
Assembly |
Stabilizer
Link
|
|
| Hitch |
|
|
| Bar |
|
|
| Assembly |
Swivel |
|
|
|
Wheel |
|
|
|
| Figure 1 |
|
|
I | H | B | C |
A | |||
J |
|
| E |
|
|
| |
G |
|
|
|
E
D
F
M
N
Figure 2
Remove the tiller, all loose parts and hardware pack from the carton before discarding the carton.
Contents of Hardware Pack:
(See Figure 2)
A(1) Flat Washer 1/2" I.D. x 1" O.D.
B(1) Sleeve
C(1) Ferrule
D(2) Large Flat Washers
E(3) Hairpin Clips
F(1) Hairpin Clip
G(1) Hex Nut
H(1) Shoulder Bolt
I(1) Clevis Pin
J(1) Flat Washer 1/2" I.D. x 15/16" O.D.
K(1) Spacer (Not Shown)
L(1) Lock Washer (Not Shown)
M(1) Flat Wash 5/8 ID x 1 1/4 OD
N(1) Hairpin
For shipping purposes, the engine oil dipstick has been placed between the engine and the gas tank. Insert dipstick into oil fill tube before operating the unit.
SECTION 2: ASSEMBLY INSTRUCTIONS
Hairpin | Flat |
Clip (E) | Washer (D) |
Flat |
|
Washer (D) | Spacer (K) |
Swivel |
|
Wheel |
|
Shaft |
|
Figure 3 |
|
Shoulder Bolt (H) | Hex Nut |
| (G) |
Lock
Washer (L)
Stabilizer Link
Figure 4
IMPORTANT: This unit is shipped WITHOUT GASOLINE or OIL. After assembly, service engine with gasoline and oil as instructed in the separate engine manual packed with your unit.
NOTE: Reference to right or left hand side of the mower is observed from the operating position.
1.Place spacer (K), then one flat washer (D) over swivel wheel shaft. Place swivel wheel in position on tiller. See Figure 3. Next, place other flat washer (D) over swivel wheel shaft. Secure with hairpin clip (E). See Figure 3.
2.Assemble the stabilizer link to front of chain case on tiller. Secure with shoulder bolt (H), lock washer (L) and hex nut (G). See Figure 4.
4
