A | Wire | Switch | |
Lead | |||
|
Adapter
Harness
Ground
Wire 
Adapter
Harness
B
Wire Harness
on
Tractor
Tiller Seat
Wire Wire
Harness Lead
Figure 13
14.There are two different types of seat safety switches. Refer to Figure 13A and Figure 13B.
If the seat switch on your tractor is as shown in Figure 13A, assemble the adapter harness as follows.
•On units with a
and four bolts, lock washers and nuts from the fender and running boards.
•Unplug the wire lead from the switch located on the right hand seat bracket. Plug the end of the adapter harness into the switch on the seat bracket.
•Plug the wire lead on the tractor into the same end of the adapter harness.
•Attach the ground wire to a bolt on the tractor frame.
•Plug the other end of the wire adapter into the wire harness on the tiller.
NOTE: It is not necessary to remove the wire adapter from your unit when the tiller is removed.
If your tractor is equipped with a plug on the seat as shown in Figure 13B, connect the wire harness on the tiller to the tractor as follows. Disconnect the wire lead under the seat of the tractor from the wire harness on the tractor. Connect the plug on the tiller wire harness to the wire lead on the seat. See Figure 13B.
WARNING: When removing the tiller attachment, make certain to reconnect the wire lead under the seat to the wire harness on the tractor. Failure to do so could result in serious personal injury.
The seat switch is a safety device, designed for your protection. Never attempt to bypass its operation.
15.Raise and lower the tractor lift lever a couple of times to make sure that the tiller tines are going up and down.
This tiller attachment is not designed to be raised off the ground by the tractor lift lever. It is designed to trail behind the tractor. The lift lever is only used to raise the lower the tines.
SECTION 3: OPERATION
GAS AND OIL FILL-UP
Service the engine with gasoline and oil as instructed in the separate engine manual packed with your mower. Read instructions carefully.
WARNING: Never fill fuel tank indoors, with engine running or until the engine has been allowed to cool for at least two minutes after running.
TO START ENGINE
1.Attach spark plug wire to spark plug.
2.Place the tine clutch rod in the disengaged position. See Figure 14.
7
Pull Forward | Push Back |
To Disengage | To Engage |
Tine Clutch Rod
Figure 14
