![](/images/new-backgrounds/1100458/10045825x1.webp)
X. Instrument Panel
9 | 3 |
|
|
| 7 |
| 4 |
| 8 | Green | |
|
|
|
|
| |||||||
|
|
|
|
|
| ||||||
|
|
|
|
|
|
|
|
|
| Range | |
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
2
1
| HOURS 1/10 |
FUEL | RPM |
E
F | 0 | x1000 | 4 |
|
|
|
|
|
|
|
|
5 6
Figure 11
1. Fuel Gauge
The fuel gauge monitors the fuel level in the fuel tank. The needle pointing to the right indicates a full tank. The ignition switch must be in the ON position to activate the fuel gauge.
2. Tachometer
The tachometer shows the engine speed in revolu- tions per minute (RPM). Optimal engine operating speed is approximately
3. Battery Indicator Light
•Bulb illuminates and battery voltage is displayed briefly when the ignition switch it turned to the "ON" position.
•Illuminates to indicate the battery voltage has dropped below 11.5
4. Oil Pressure Indicator
This warning lamp indicates low engine oil pressure. If this indicator illuminates, stop the tractor immediately and check the engine oil level. If the oil level is within the operating range, but the light remains on, contact your Cub Cadet dealer. NOTE: The oil pressure indicator may illuminate when the key switch is turned to the on position, but should turn off when the engine is started.
5. PTO Engaged Indicator
This indicator illuminates whenever the PTO switch is pulled upward in the "ENGAGED" position while the key switch is turned to the "ON" position. Check this indicator if the engine will not crank with the key switch in the "START"
6. Brake Engaged Indicator
This indicator illuminates whenever the brake pedal is fully depressed or the parking brake is engaged and the key switch is turned to the "ON" position. Check this indicator if the engine will not crank when the key switch is turned to the "START" position— the indicator should be illuminated. If necessary, fully depress the brake pedal.
7. Hour Meter/Battery Display
The hour meter records the hours and tenths of an hour (right most digit) that the tractor has been operated.
•The hour meter is activated when the key switch is turned to the “ON” switch position. Because the key switch may be accidentally left in the "ON" position, a record of the actual hours of operation should be kept to assure mainte- nance procedures are completed according to the schedule in this manual.
•When the key switch is turned to the "ON" position, the battery indicator light briefly illuminates and the battery voltage is briefly displayed. The display then changes to the accumulated hours.
8.Engine Coolant Temperature Light Illumination of this warning lamp indicates the engine coolant temperature has risen above the prescribed operating range. If the light comes on while operat- ing the tractor, eliminate all loads and try cooling the engine by running at mid throttle for a few minutes. Stop the engine and allow to cool; then check for possible causes (e.g. low coolant level, plugged radi- ator screen).
9.Glow Plug Indicator Light
Illuminates when the ignition switch is turned to the ON position. The light remains lit for a preset time while the glow plugs heat the precombustion chambers of the diesel engine.
13