6
Trouble
Shooting
For repairs beyond the minor adjust- ments listed here, contact an authorized service dealer.
Problem |
| Cause |
| Remedy |
|
|
|
|
|
Engine fails to start | 1. | Spark plug wire disconnected. | 1. | Connect wire to spark plug. |
| 2. | Fuel tank empty or stale fuel. | 2. | Fill tank with clean, fresh gasoline. |
| 3. | Throttle control lever not in correct | 3. | Move throttle lever to start position. |
|
| starting position (if equipped) |
|
|
| 4. | Choke not in ON position. | 4. | Move lever to ON position. |
| 5. | Blocked fuel line. | 5. | Clean fuel line. |
| 6. | Faulty spark plug. | 6. | Clean, adjust gap, or replace. |
| 7. | Engine flooding. | 7. | Refer to the engine manual packed |
|
|
|
| with your unit. |
|
|
|
|
|
Engine runs erratic | 1. | Spark plug wire loose. | 1. | Connect and tighten spark |
|
|
|
| plug wire. |
| 2. | Unit running on CHOKE. | 2. | Move choke lever to OFF. |
| 3. | Blocked fuel line or stale fuel. | 3. | Clean fuel line; fill tank with clean, |
|
|
|
| fresh gasoline. |
| 4. | Gas cap vent plugged. | 4. | Clear vent. |
| 5. | Water or dirt in fuel system. | 5. | Drain fuel tank and carburetor. |
|
|
|
| Refill with fresh fuel. |
| 6. | Dirty air cleaner. | 6. | Refer to the engine manual packed |
|
|
|
| with your unit. |
| 7. | Carburetor out of adjustment. | 7. | Refer to the engine manual packed |
|
|
|
| with your unit. |
|
|
|
|
|
Engine overheats | 1. | Engine oil level low. | 1. | Fill crankcase with proper oil. |
| 2. | Dirty air filter. | 2. | Refer to the engine manual packed |
|
|
|
| with your unit. |
| 3. | Air flow restricted. | 3. | Remove blower housing and clean. |
| 4. | Carburetor not adjusted properly. | 4. | Refer to the engine manual packed |
|
|
|
| with your unit. |
|
|
|
|
|
Tines do no engage | 1. | Foreign object lodged in tines. | 1. | Stop tiller completely, check and |
| 2. | Tine clevis pin(s) missing. |
| discard foreign object. |
|
|
| ||
| 3. | Belt worn and/or stretched. | 2. | Replace tine clevis pin(s). |
|
|
| ||
| 4. | Pulley and idler not in correct adjust- | 3. | Replace belt. |
|
|
| ||
|
| ment. | 4. | Take unit to authorized service |
|
|
|
|
|
22
