SECTION6: MAKINGADJUSTMENTS
adjustments while the engine is running,
_lb WARNING: Never attempt to make any except where specified in the operator's manual.
wire(s) and ground against the engine before
WARNING: Disconnect the spark plug performing any adjustments, repairs or maintenance.
StandardAdjustmentSeat
To adjust the position of the seat, loosen the two hex screws on the bottom of the seat. See Figure 11. Slide
the seat forward or backward as desired. Retighten the two screws.
QuickAdjustmentSeat(if soequipped)
To adjust the position of the seat on models so equipped, move the seat adjustment lever (located under the seat) to the left and slide the seat forward or backwards. See Figure 12. Make sure seat is locked into one of the six adjustment positions before operating the lawn tractor.
KnobAdjustmentSeat(if soequipped)
To adjust the position of the seat on models so equipped, loosen the two knobs on the bottom of the seat. See Figure 13. Slide the seat forward or backward as desired. Retighten the two knobs.
DeckLevelingAdjustment
,_ WARNING:heavy gloves toProtectgrasp theyourcuttinghandsbladebywearing.
NOTE: Check the tractor's tire pressure before
performing any deck leveling adjustments. Refer to Tires later in this section for further information
regarding tire pressure.
The front of the cutting deck is supported by two lift
links, one of which can be adjusted to level the deck from both front to rear & side to side. The front of the
deck should be between
oWith the tractor parked on a firm, level surface, place the deck engagement!lilt lever in the top cutting height notch (not BLADES STOP) position.
oRotate the blade nearest the discharge chute so that it is parallel with the tractor.
Hex Screws
Figure 11
Seat
Adjustment
Lever
(3
Figure 12
Knobs
Figure 13
16
