AttachingTheSeat

Seat styles vary by tractor mode! and there are three different styles available:

Standard Adjustment

Quick Adjustment &

Knob Adjustment

Refer to Figure 3, Figure 4 and Figure 5 to identify which your tractor's seat style and follow appIicabIe instructions below.

NOTE: For shipping reasons, seats are either fastened to the tractor seat's pivot bracket with a plastic tie, or mounted backward to the pivot bracket. In either case, free the seat form its shipping position and remove the two hex screws (or knobs, on models so equipped) from the bottom of seat before proceeding with applicable instructions below.

StandardAdjustmentSeat

1.

Position the shouIder

screws (found on the base of

 

the seat)

inside

the slot openings in the seat pivot

 

bracket.

Figure

3.

 

2.

Slide the

seat slightly

rearward in the seat pivot

Standard Adjustment

Hex Screw_

Shoulder

OpenSrr;si _

in Slot

Figure 3

Quick Adjustment

bracket, lining up the rear slots in the pivot bracket

with the remaining two holes in the seat'sbase.

Seat Stop

)

3. Select desired position for the seat, and secure with

the two hex screws removed earlier. See Figure 3.

QuickAdjustmentSeat

NOTE: ff your seat was shipped mounted backwards on the seat pivot bracket, pull out the tab found on the seat stop and hold it open while sliding the seat off the seat pivot bracket. See Figure 4.

1.Line up the plastic seat spacers with the slots in seat pivot bracket.

2.Slide seat in until front seat spacer engages the seat stop. See Figure 4.

WARNING: Before operating this machine, make sure the seat is engaged in the seat stop, stand behind the machine and pull back on seat until fuIly engaged into stop.

KnobAdjustmentSeat

1.Position the shoutder screws (found on the base of the seat) inside the slot openings in the seat pivot bracket. Figure 5.

2.Slide the seat slightly rearward in the seat pivot bracket, Iining up the rear slots in the pivot bracket with the remaining two holes in the seat'sbase.

3.Select desired position for the seat, and secure with the two knobs removed earIier. See Figure 5.

\

Pivot Bracket

Figure 4

KnobAdjustment

Knobs

Shoulder

Screws

Opening

Figure 5

Page 9
Image 9
Bolens 660 manual AttachingTheSeat