Bolens 933 SWE, 930 SWE warranty Service, Belt Removal Preparation, Auger Belt Replacement

Service

Belt Replacement

Belt Removal Preparation

1.Disconnect the chute crank assembly at the discharge chute end by removing the hairpin clip and the flat washer. Refer to Figure 7-1.

Figure 7-1

2.Remove the plastic belt cover on the front of the engine by removing the three self-tapping screws. See Fig. 7-2.

Figure 7-2

3.Loosen the bolt shown in Figure 7-3 securing the belt keeper bracket and remove the other bolt. Push the belt keeper bracket up off the engine pulley. Refer to Figure 7-3.

7

Remove

Loosen

Figure 7-3

Auger Belt Replacement

To remove and replace your snow thrower’s auger belt, proceed as follows:

1.Remove the hairpin clip and flat washer from the ferrule in order to disconnect the auger idler rod from the brake bracket assembly. See Figure 7-4.

NOTE: Make sure to maintain the location of the ferrule on the idler rod.

Figure 7-4

2.Slip the auger control belt (the front belt) off the engine pulley.

3.Pull the brake bracket assembly towards the cable guide roller and unhook the auger cable “Z” fitting. Refer to Figure 7-5.

18