Assembly with a separate speaker system
If you are using a speaker system other than the
After making holes on the speaker base where indicated (make sure they line up with the screw holes on the speaker support), secure the speaker to the speaker support using commercially available wood screws as shown below.
Speaker | Fastening nut | |
base |
| |
Speaker | Screw holes | |
for securing | ||
support | ||
speaker | ||
| ||
| Commercially | |
| available wood | |
| screw |
Cabinet and stand maintenance
•Use a polishing cloth or dry cloth to wipe off dust and dirt.
•If the cabinet or stand is very dirty, use a soft cloth dipped in some neutral cleanser diluted 5 or 6 times with water. Finally, wipe again using a dry cloth. Do not use furniture wax or cleaners.
•Never use thinners, benzine, insecticide sprays and other chemicals on or near the cabinet or stand, since these will corrode the surfaces.
4
En
Specifications |
|
External dimensions |
|
.................................. 400 (W) mm x 604 (H) mm x 513 (D) mm | |
153/4 (W) in. x 233/4 (H) in. x 203/16 (D) in. | |
Weight | 17.8 kg / 39 lbs. 4 oz. |
Supplied accessories |
|
Stand base plates | 2 |
Speaker supports | 2 |
Stems | 4 |
Spikes (with attached nuts) [SBA6053] | 8 |
Spike bases [SLA1057] | 8 |
Screws (Bind head, M5xL62) [SBA6050] | 4 |
Screws (Bind head, M5xL36) [SBA6048] | 4 |
Screws (Bind head, M6xL40) [SBA6054] | 24 |
Spring washers [SBE6005] | 4 |
Washers [SBE6006] | 4 |
Operating instructions [SRD6056] | 1 |
•Specifications and design subject to possible modifica- tion without notice, due to improvements.
•The product number are listed above in square brackets.
Replacement part numbers
Part name | Part no. |
• Protector (Bottom) | SHA6095 |
• Protector (Middle) | SHA6096 |
• Protector (Top) | SHA6097 |
• Protector | SHA6098 |
• Packing case | SHG6129 |
• Protection sheet | SHC6044 |
• Protection sheet | SHC6045 |
• Protection sheet | SHC6046 |
Published by Pioneer Corporation.
Copyright © 2006 Pioneer Corporation.
All rights reserved.
