Bolens BL150 manual Starting Instructions, Starting Position

_AIAD!_ _,_, Operatethisunitonlyina

• well-ventilatedoutdoor

areaCarbonmonoxideexhaustfumescanbelethalin.

aconfinedarea.

WARNING" Avoid acddental starting.

• Make sure you are in the

starting position when pulling the starter rope (Fig. 8). To avoid serious injury, the operator and unit must be in a stable position while starting.

STARTING INSTRUCTIONS

1, Mix gas with oil. Fill fuel tank with fuel/oil mixture. See Off and Fuel Mixing Instructions.

On/Off Stop

Control

\

Start/On (I)

2.Make sure the On/Off Stop Control in the ON ( I ) position (Fig. 6).

Fully press and release the primer bulb 10 times, slowly. Some amount of fuel should be visible in the primer bulb and fuel lines (Fig. 7). If you can't see fuel in the bulb, press and release the bulb as many times as it takes before you can see fuel in it.

4.Place the blue choke lever in Position 1 (Fig. 7).

5.Crouch in the starting position (Fig. 8) and squeeze the throttle control. Pull the starter rope out with a controlled and steady motion 5 times.

F_g. 6

Position 2

Position 1

Position 3

NOTE: The unit uses E-Pull Version 3TM, which significantly reduces the effort required to start the engine. You must pull the starter rope out far enough to hear the engine attempt to start. There is no need to pull the rope briskly-- there is no harsh resistance when pulling. Be aware that this starting method is vastly

different from (and much easier than) what you may be used to.

6.Place the blue choke lever in Position 2.

7.While squeezing the throttle control, pull the starter rope out with a controlled and steady motion until the engine starts.

8.Keep the throttle squeezed and allow the engine to warm up for 15 to 30 seconds.

9.Place the blue choke lever in Position 3. The unit is ready for use.

F,,, The engine does not start, go back to step 3.

IF...

__ The engine fails to start after a few attempts, place the blue choke lever in Position 3 and squeeze the throttle control. Pull the starter rope briskly 3 to 8 times. The engine should start. If not, repeat.

IF WARM... If the engine is already warm, make sure the On/Off Stop control is in the ON position and start the unit with the blue choke lever in Position 2. After the unit starts, move the blue choke lever to Position 3.

Blue Choke

Lever

Primer Bulb

F_g. 7

Starting Position

Starter Rope

STOPPING iNSTRUCTIONS

1.Release your hand from the throttle control. Allow the engine to cool down by idling.

2. Put the On/Off Stop Control in the OFF (O) position. Throttle Controt

F_g. 8