HOLDING THE TRIMMER
WARNING: AHways wear eye, hearing, foot and
body protection to reduce the risk of injury when operating this unit,
Before operating the unit, stand in the operating position (Fig. 9). Check for the following:
The operator is wearing eye protection and proper clothing
•With a
The operator's Heftarm is straight, the Hefthand hoHding the
•The unit is at waist HeveH
The cutting attachment is paraHeHto the ground and easiHycontacts the grass without the need to bend over
BL150BL100
Fig. 9
ADJUSTING TRiMMiNG LiNE LENGTH
The Bump Head TM cutting attachment allows you to release trimming line without stopping the engine. To release more line, lightly tap the cutting attachment on the ground (Fig, 10) while operating the trimmer at high speed,
NOTE: Always keep the trimming line fully extended,
Line release becomes more difficult as cutting line becomes shorter
BL100
Fig. 10
Each time the head is bumped, about 1 inch (25,4 mm) of trimming line releases, A blade in the cutting attachment shield will cut the line to the proper length if any excess line is released,
For best results, tap the bump knob on bare ground or
hard soil, If you attempt a line release in tall grass, the engine may stall, Always keep the trimming line fully extended, Line release becomes more difficult when the
cutting line gets shorter,
NOTE: Do not rest the Bump Head TM on the ground while the unit is running.
personal inJuryor damage to the unit,
Some line breakage will occur from:
•Entanglement with foreign matter Normal line fatigue
Attempting to cut thick, stalky weeds
•Forcing the line into objects such as walls or fence posts
TiPS FOR BEST TRiMMiNG RESULTS
•Keep the cutting attachment parallel to the ground,
•Do not force the cutting attachment, Allow the tip of the line to do the cutting, especially along walls. Cutting with more than the tip will reduce cutting efficiency and may overload the engine,
•Cut grass over 8 inches (200 mm) by working from top to bottom in small increments to avoid premature line wear or engine drag,
Cut from right to left whenever possible. Cutting to the left improves the unit'scutting efficiency, Clippings are thrown away from the operator,
Slowly move the trimmer into and out of the cutting area at the desired height. Move either in a forward- backward or
•Trim only when grass and weeds are dry,
•The life of your cutting line is dependent upon; Adherence of the listed trimming techniques
What vegetation is cut
Where vegetation is cut
For example, the line will wear faster when trimming against a foundation wall as opposed to trimming around a tree,
DECORATIVE TRiMMiNG
Decorative trimming is accomplished by removing all vegetation around trees, posts, fences, etc,
Rotate the whole unit so that the cutting attachment is at a 30° angle to the ground (Fig, 11),
BL150
\\
Fig. 11
10
