CONTROLS
FIGURE 9.
THROTTLECONTROL
The throttle control is used to regulate the engine speed. To get maximum efficiency from cutting, the throttle should be in the FAST position when operating the mower. See figure 9.
CHOKECONTROL
The choke control is located on the dashboard and is operated manually. See figure 9.
SHIFT LEVER
The shift lever is located in the center of the console and has three positions, FORWARD, NEUTRAL and REVERSE. See figure 9. The
gears.
SPEEDCONTROLLEVER
The speed control lever allows you to regulate the ground speed of the lawn tractor. See figure 10. To select the ground speed, depress clutch pedal. Push speed control lever outward and move backward to slow lawn tractor, move forward to increase speed. When desired speed has been obtained, release lever in that position. Whenever clutch is engaged, unit will automatically go to the
IGNITION SWITCH
Turn the key to the START position to start the engine. When the engine is running, let the key return to the ON position. To stop the engine, turn the key to the left to the OFF position and remove it to prevent accidental starting. See figure 9.
LIGHTSWITCH
Push the light switch to turn on the lights. The lights will only operate when the engine is running. See figure
9.
AMMETER
The ammeter registers the rate of battery charge or discharge. The ammeter will register on the discharg- ing side when starting the engine. It should register on the opposite side (charging) when the engine is run- ning in the fast position until the battery is completely charged. With a fully charged battery or with the engine idling, the ammeter will not show a charge. See figure 9.
CLUTCH-BRAKEPEDAL
The
NOTE: The
PARKINGBRAKE
The speed control lever is used to set the parking brake. To set the parking brake, depress the
To release the parking brake, depress the
NOTE: The parking brake must be set if the operator leaves the seat with the engine running.
10