Bolens MTD7122B09 manual Storage, Off-Season, Jump Starting, Tires

BATTERYREMOVALOR INSTALlATION

A WARNING: When removing the battery,

follow this order of disassembly to prevent

the screwdriver from shorting against the

frame.

1.Remove the Negative cable.

2.Remove the Positive cable. To install a battery:

1.Attach the Positive cable.

2.Attach the Negative cable.

JUMP STARTING

1.Attach the first jumper cable from the Positive ter- minal of the good battery to the Positive terminal of the dead battery.

2.Attach the second jumper cable from the Negative terminal of the good battery to the FRAME OF THE

UNIT WITH THE DEAD BATTERY.

AWARNING: Failure to use this starting pro- cedure could cause sparking, and the gas in either battery could explode.

COMMONCAUSESFOR BATTERYFAILUREARE:

1.Overcharging

2.Undercharging

3.Lack of water

4.Loose holds downs and/or corroded connections

5.Excessiv~ loads

6.Battery :':trolyte substitutes

7.Freezing of electrolyte

NOTE: THESE FAILURES DO NOT CONSTITUTE WARRANTY.

TIRES

Recommended operating tire pressure is approximately 12 p.s.i. (check sidewall of tire for tire manufacturer's recommended pressure). Maximum tire pressure under any circumstances is 30 p.s.i. Equat tire pressure should be maintained on all tires.

When installing a tire to the rim, be certain rim is clean and free of rust. Lubricate both the tire and rim generously. Never inflate to over 30 p.s.i. to seat beads.

AWARNING: Excessive pressure (over 30

p.s.i.) when seating beads may cause

tire/rim assembly to burst with force suffi- cient to cause serious injury.

BATTERYMAINTENANCE

1.Check periodically (every two weeks or before and after charging) to be sure electrolyte level is above the lowest line on battery. Add only distilled water or a good quality drinking water. NEVER add ad- ditional acid or other chemicals to battery after in- itial activation.

2.The battery should be checked with a hydrometer after every 25 hours of operation. If the specific gravity is less than 1.225. remove battery and recharge.

3.Coat the terminals and exposed wiring with a thin coat of grease or petroleum jelly for longer service and protection against electrolyte corrosion,

4.The battery should be kept clean. Any deposits of acid should be neutralized with soda and water. Be careful not to get this solution in the cells.

BATTERYSTORAGE

1.Charge battery using normal methods. NEVER store discharged battery as it will not recover.

2.When storing battery for extended periods, discon- nect battery cables. Removing battery from unit is recommended.

3.Store in cold, dry place.

4.Recharge battery whenever the specific gravity is less than 1.225, before returning to service, or every two months, whichever occurs first.

STORAGE

If the machine is to be inoperative for a period longer than 30 days, prepare for storage as follows.

1.Clean the engine and the entire unit thoroughly.

2.Lubricate all lubrication points. Wipe the entire machine with an oiled rag to protect the surfaces.

3.Refer to the engine section of this manual for cor- rect engine storage instructions. The engine must be completely drained of fuel to prevent gum deposits from forming on essential carburetor parts, fuel lines and fuel tanks.

4.Refer to battery storage instructions on this page.

5.Store unit in a clean, dry area.

NOTE: When storing any type of power equipment in an unventilated or metal storage shed, care should be taken to rustproof the equipment. Using a light oil or silicone, coat the equipment, especially any chains, springs, bearings and cables.

18

OFF-SEASON