INFORMATION ABOUT WATER TEMPERATURE

The AquaStar 125B LPS and 125B NGS water heaters have a gas control that modulates burner output in response to water flow. Its purpose is to ensure that the hot water temperature will remain steady, although the water flow demand might vary (down to 1/2 gal/minute). The AquaStar 125 B”S” will produce a temperature rise of approximately 90°F at flow rates between 0.5 and 1.8 gallons per minute unless the water has been preheated. If the incoming water is already hot, the burners will modulate accordingly so the outlet temperature will not exceed 140°F.

Cold water will have to be mixed in at the faucet to produce comfortable temperatures. Mixing in cold water will produce higher flow rates and will reduce risk of scalding. Note: 105° is the maximum recommended temperature for a hot bath. Handwashing should not be done in water hotter than 112°

-and cooler for older adults, young children or persons with sensory loss. Remember that scalding can occur in 20 seconds with 135° water.

MAINTENANCE AND SERVICE

(see maintenance table on back of manual) Approximately once a year, the AquaStar should be checked and cleaned. To remove the front cover, first remove the incandescent particle tray, then unscrew the central screw located at the bottom of the front cover. Pull main cover out toward you and lift up and out. THE FOLLOWING OPERATIONS SHOULD BE PERFORMED BY A QUALIFIED SERVICE PERSON:

Vent System: Should be checked annually. Clean and repair as needed.

Water Valve (Part # 8707002393): The water valve on this heater should be serviced periodically. Lubricate component #27 on page 14 with a small amount of silicon, faucet or lithium grease every two years to keep its o rings fresh and pushrod sliding smoothly. Every 3-5 years replace components #27 and #29 on page 14. The frequency will depend on the mineral content of the water and conditions of use or whenever signs of corrosion appear at the gas and water valve joint. Periodically check that the water inlet filter (#34 on page 14) is clean as well.

Pilot Flame: The pilot flame should burn with a clean sharp blue flame and should resemble the diagram in Fig 8. If the flame is yellow, or if the pilot knob has to remain depressed for a long time in order to keep the pilot lighted, the pilot burner and or the pilot burner orifice may need to be cleaned (NG), the orifice may need to be replaced(LP), and or the air screen may need cleaning. The pilot flame should envelop approximately 10 mm (3/8") of the tip of the thermocouple. If it is too small, the pilot burner must be cleaned. To obtain a spark, the position of the Piezo igniter electrode should be approximately 3 mm (1/8") from the pilot burner tip.

3mm

Correct gap between pilot burner tip and piezo electrode tip

Piezo Electrode

Air screen filter

10mm

3/8”

 

 

 

 

Thermocouple

Piezo

Electrode

Fig. 8 - Characteristic Pilot Flame

To clean the pilot burner and/ or the pilot orifice : Turn off the gas at the unit. Remove the cover of the heater. To do so, remove incandescent particle tray and unscrew the central screw located at the bottom of the front cover. Pull main cover out toward you and lift up and out. Pull the air screen off, wash it and blow any lint off (See Fig 9). The pilot orifices should also be cleaned or replaced. Do not enlarge the orifice. Do not use any wire or sharp object to clean orifices. Natural gas orifices are large enough that you can usually clean them by blowing through them. LP orifices, on the other hand, are too small to clean and should be replaced. See #3 in Trouble Shooting Section. To access the pilot orifice, remove 2 screws holding pilot assembly in place. Then loosen compression fittings to expose pilot orifice.

AIR SCREEN

PILOT ORIFICE

Fig. 9 - Pilot burner with air screen/ pilot orifice

Main Burner Flames: The main burner flames should be blue, with a more intense blue cone in the center core. Yellow flames could be a sign of wrong size gas orifices or dirty burners, or a blockage on the heat exchangers fins.

6 720 606 518

13

Page 12 Page 14
Page 13
Image 13
Bosch Appliances 125B LPS, 125B NGS Maintenance and Service, Pilot burner with air screen/ pilot orifice
Page 12 Page 14

125B NGS, 125B LPS specifications

Bosch Appliances has long been a revered name in the home appliance industry, recognized for its commitment to quality, innovation, and energy efficiency. Among its impressive lineup, the Bosch 125B NGS and the Bosch 125B LPS stand out for their advanced features and technologies that enhance the cooking experience in modern kitchens.

The Bosch 125B NGS is a gas cooktop designed for those who appreciate the precision of gas cooking. With its sleek stainless-steel design and intuitive controls, this appliance adds a touch of elegance to any kitchen. One of its main features is the rapid heating capability, thanks to the powerful burners that provide quick and even heat distribution. The cooktop includes multiple burner sizes, allowing users to choose the right heat level for various types of cooking, from simmering sauce to boiling pasta.

Additionally, the Bosch 125B NGS is equipped with an automatic re-ignition system, enhancing safety by ensuring that burners reignite if they go out. This feature is particularly beneficial in busy kitchen settings where distractions can occur. The continuous grate design allows for easy movement of pots and pans across the cooking surface, making multi-tasking a breeze.

On the other hand, the Bosch 125B LPS offers an electric alternative with a more modern flair. This built-in induction cooktop harnesses the power of induction technology, which uses magnetic fields to directly heat pots and pans. One of the key characteristics of this model is its exceptional energy efficiency, as it only heats the cookware, resulting in less wasted energy and cooler cooking surfaces. The Bosch 125B LPS features a touch control panel that allows for precise temperature adjustments at the touch of a finger.

Moreover, the model includes safety features such as a child lock and automatic shut-off, ensuring peace of mind for families. The sleek and minimalist design of the Bosch 125B LPS makes it a favorite among those who value aesthetics as much as functionality.

Both the Bosch 125B NGS and 125B LPS reflect the brand’s dedication to high-quality craftsmanship, innovative technology, and user-friendly operation, making them exemplary choices for anyone looking to elevate their culinary experience. Whether you prefer the hands-on approach of gas cooking or the quick precision of induction, Bosch offers reliable and versatile solutions to meet your kitchen needs.
Top Page Image Contents