Installation/Operating Instructions
Invented for life
PRE-SET TEMPERATURE
The Bosch water heaters are factory
The appliance can also be fitted with temperature selector pads, available as an accessory item. When fitted, the hot water will be delivered at the temperature displayed on the selector pad.
There are two versions of remote controls available, the 66 series which has bath fill alarm and the 67 series which has bath fill stop.
The two different series must never be connected to the same water heater. The sub controller cannot be used as a sole controller.
There is a Main, Bathroom and Ensuite control available in each series, never connect more than one of each control type to the water heater (except an extra sub controller as the fourth controller.)
Only one of each type can be connected to the appliance.
| 67 series (Bathstop) | 66 series (Bathfill) |
| |
|
|
|
| |
Main controller | YPRM67XBN | YPRM66XB | Max temperature 75° C # | |
YPRM67XB | ||||
|
|
| ||
|
|
|
| |
Bathroom controller | YPRS67XBN | YPRS66XB | Max temperature 50°C | |
YPRS67XB | ||||
|
|
| ||
|
|
|
| |
Ensuite controller | YPRP62XB | YPRP62XB | Max temperature 50°C | |
|
|
|
|
#MAXIMUM TEMPERATURE IS CONTROLLED BY THE MAXIMUM DEFAULT TEMPERATURE SET IN THE WATER HEATER
TEMPERATURE SELECTOR PAD INSTALLATION DETAILS
Main, Bathroom & Sub Control
Select a suitable flat, dry location away from direct sunlight.(Direct sunlight could make it difficult to see display)
Cut an opening in wall through center of where the remote control is to be installed, pull cable from wall cavity through opening. Attach cable to control. Remove cover from remote control, locate control so that the wiring is not caught between the wall and the remote control.
Secure control to wall using the screws provided and refit front cover. Ensure that sufficient cable length is left to remove control if necessary.
TEMPERATURE SELECTOR PAD WIRING DETAILS
1Remove the front cover of the water heater and locate the PCB on the right hand side of the cabinet.
2Locate the two control terminals on the PCB.
(Please be aware that all controller terminals connect back to the same two points on the PCB)
11