Bosch Appliances 15SBI Programmer Operating Instructions, Programme Step, Standard Programme

PROGRAMMER OPERATING INSTRUCTIONS

TO SET PRESENT TIME AND DAY

Set right switch to RUN.

Press HR & MIN buttons together (until colon stops flashing)

After 15 seconds the colon will start flashing again signifying the settings cannot be changed. Repeat this step if you still want to set time and day.

Press DAY button until arrow points to correct day.

Press HR and MIN buttons separately until correct time is displayed.

Set right switch to DHW then back to RUN (or leave for 15 seconds) to start the clock.

Permanent off		Fig. 2.				Normal run mode
Timed programme						Set DHW programme
Permanent on	I AUTO O		RUN DHW CH			Set CH programme
Monday to Sunday						Channel 1 (DHW)
	M	T W	Th F	S	Su	Channel 2 (CH)
		8:37		3
Actual time or set time				1 2
						Demand symbol (light bulb)
		DAY	HR	MIN	ADV	Advanced symbol
	P
Step through programme			Set
			Reset			Programmer step number
						Advance button
Set actual or	Set time or					Set time or
programme day	programme hours					programme minutes

TO SET PROGRAMME TIMES

This programmer provides eight switch periods per channel, with a day selection of Mon...Fri, Mon...Sat, Sat/sun, all days together or all days individually. If it is considered confusing to programme all variations, the following describes two levels of setting the programme; simple or full-function;

SIMPLE PROGRAMME SETTING

The programmer has an in-built programme of ‘standard’ switching times shown in the table. These may be changed to suit your specific requirements.

PROGRAMME STEP	STANDARD PROGRAMME
	DHW MON-FRI	CH MON-FRI
1	6.30am	6.30am
2	8.30am	8.30am
3	4.30pm	4.30pm
4	10.30pm	10.30pm
	SAT-SUN	SAT-SUN
5	7.00am	7.00am
6	9.00am	9.00am
7	4.00pm	4.00pm
8	11.00pm	11.00pm

2