OPERATION OF
CONTROLS
OPERATING SWITCH
In the ‘ ’ position there is no mains electricity to the
appliance.
In the ‘I’ position mains electricity is connected to the
appliance.
CENTRAL HEATING TEMPERATURE CONTROL
The position of this knob will determine the temperature of the water delivered to the radiators between the ‘I’ and ‘MAX’ position. When the knob is turned
DOMESTIC HOT WATER TEMPERATURE CONTROL
The position of this knob will determine the temperature of the water delivered at the domestic hot water taps between the ‘ ’ and the ‘MAX’ position.
By slightly reducing the flow of domestic water from the tap, the delivery temperature of the water will be further increased. This is of particular advantage in the winter, for example to increase bath water temperature. Also this will provide an added advantage of reducing the delay before hot water is obtained.
FACIA MOUNTED PROGRAMMER (if fitted)
Your installer may have mounted either a mechanical or an elec- tronic programmer into the facia of your appliance. Operating instruc- tions are supplied with the programmer.
RESET BUTTON
Press this button in for five seconds if any of the indicator lights are flashing slowly.
SYSTEM PRESSURE GAUGE
The red needle has been set to show the sealed system pressure which is required for the appliance to operate effectively. The grey needle will show the actual pressure in the system. This does not apply to any open vent system.
8