Bosch Appliances 3931A Removing the Dust BAG, Removing the Filter Cartridges, Replacing the Motor

BM 1609929K45 08-06 8/14/06 11:42 AM Page 7

FIG. 4	FILTER
	CARTRIDGE
	CONTROL UNIT TOP
	SECTION
FILTER	CONTROL UNIT
COMPARTMENT	BOTTOM SECTION
LOCK
	MOTOR PROTECTION
	FILTER

2.Grasp a new dust bag at the flange. Push it over the bottom of the connection piece first and then over the catch on the top of the connection piece. Make sure that the full length of the dust bag faces against the inner wall of the canister (Fig. 2).

3.Re-attach the control unit.

4.Lock the canister latches.

REMOVING THE DUST BAG

1.Unlock the canister latches and remove the control unit.

2.Pull the dust bag away from and off of the connection piece.

3.Close the opening in the dust bag by folding down the lid

4.Remove bag and dispose of properly.

REMOVING THE FILTER CARTRIDGES

1.First, clean the filters by setting the mode selector switch to the PULSE-CLEAN™ mode, which takes only 10 seconds.

2.To open the filter access compartment, use a coin to rotate the filter compartment lock by 1/4 turn in the direction of the arrow and push the lock in.

3.Lift up the top section of the control unit.

4.Grasp the filter cartridge by the fins, pull up and remove.

Replace a damaged filter cartridge immediately.

THOROUGH CLEANING OF THE

FILTER CARTRIDGES

If necessary, the filter cartridges can also be cleaned with a soft brush and can also be washed with water.

REPLACING THE FILTER CARTRIDGES

1.Insert new or cleaned filter cartridge and ensure firm seating.

2.Lower the top section down again.

3.With slight pressure from the top of the control unit, the filter compartment lock will snap back again.

CLEANING THE MOTOR

PROTECTION FILTERS

The motor protection filters are mostly maintenance-free. If the motor filters are dirty, it may indicate that the filter cartridges are damaged and need to be replaced. If the motor filters need cleaning, take out the motor protection filters from time to time and wash them. Allow them to dry thoroughly before reinserting.

REMOVING THE MOTOR

PROTECTION FILTERS

1.To open the filter access compartment, use a coin to rotate the lock by 1/4 turn in the direction of the arrow and push the lock in.

2.Lift up the top section.

3.Grasp the filter, pull up and remove.

REPLACING THE MOTOR

PROTECTION FILTERS (See Figure 4.)

1.Insert clean motor protection filters and ensure firm seating.

2.Lower the top section.

3.With slight pressure from the top of the control unit, the filter compartment lock will snap back again.

WAND STORAGE

The wands from the optional VAC011 wand kit can be stored in the recesses at the bottom of the rear of the container. See Figure 1.

-7-