English
ATM/POS bridge Installation Manual | EN 6 |
|
|
4.Connect your terminal to COM port 1, 2, 3 or 4 of the bridge using the supplied cable. Choose the COM 4 port on the bridge if your connection protocol is RS485.
Normally, you would use the supplied splitter cable to make this connection. For example, you remove the existing cable that connects your terminal to the printer. Use the supplied splitter cable to connect the terminal to the printer. The third connector of the splitter cable then connects to the supplied connection cable which connects to the bridge.
Supplied splitter | POS terminal |
| |
cable |
|
Supplied | Printer | |
connection cable | Digital | |
Video | ||
| ||
| Recorder |
ATM/POS bridge
Ethernet
To select the communication parameters for the ports and the network parameters, use a PC to start a configuration session as described below. The activity LED lights when the bridge is active.
Note
To download firmware to the bridge you must use the supplied RS232 cable connected to the COM3 (console) port. In this situation the cable must be connected to the bridge before it is powered.
Bosch Security Systems
